What to do if my Makita DUR182L Trimmer has abnormal vibration?
If your Makita Trimmer is vibrating abnormally, stop the machine immediately. This could be happening because one end of the nylon cord has broken. Try bumping the nylon cutting head against the ground while it is rotating to cause the cord to feed. If the problem persists, the drive system may not be working correctly, and you should seek repair from an authorized service center.
Why does my Makita Trimmer not reach maximum RPM?
If your Makita Trimmer isn't reaching its maximum RPM, it could be due to a few reasons. Ensure the battery cartridge is correctly installed as described in the manual. If the battery power is dropping, recharge it, and if recharging isn't effective, replace the battery. If these steps don't help, the drive system may not be working correctly, and you should consult an authorized service center for repair.
General| Power source | Battery |
|---|---|
| Charging time | 0.366 h |
| Operating time | 60 min |
| Battery voltage | 18 V |
| Battery capacity | 3 Ah |
| Cordless | Yes |
| Product color | Black, Blue, White |
| Uncertainty K | 1.5 m/s² |
| Rotational speed | 6000 RPM |
| Vibration emission | 2.5 m/s² |
| Sound pressure level | 79 dB |
| Cutting diameter (max) | 300 mm |
| Sound power level guaranteed | 90 dB |
| Sound power level uncertainty | 0.7 dB |
Weight and Dimensions| Depth | 253 mm |
|---|---|
| Width | 287 mm |
| Length | 1843 mm |
| Weight | 4100 g |
Details sound pressure levels and vibration emission values for different models.
Covers user familiarity, cutting element behavior, child safety, and environmental awareness.
Covers intended use, personal protective equipment, and electrical/battery safety.
Step-by-step instructions for safely starting the grass trimmer.
Covers initial use, handling, and charging precautions for battery cartridges.
Guidelines on preventing shorts, storage, disposal, and general battery maintenance.
Advice on charging frequency, temperature, and storage for optimal battery performance.
Step-by-step guide for inserting and removing the battery cartridge.
Explains how to use the power switch, lock-off lever, and indicators.
Details the use of the reversing switch for debris removal.
Describes conditions for overload and low battery voltage protection.
Instructions on adjusting the tool speed from 3,500 to 6,000 min⁻¹.
Steps for attaching the pipe to the power unit for specific models.
Crucial steps for installing the guard to prevent serious injury.
Instructions for fitting and tightening the grip onto the shaft pipe.
Steps to install the wire guard to control cutting range and prevent damage.
Guide to attaching and removing the nylon cutting head.
Instructions for correctly attaching and securing the shoulder harness.
Procedure for detaching components like the cap.
Instructions for adjusting the hanger position and shoulder harness.
Step-by-step guide on how to replace the nylon cutting line.
Identifies common problems, their causes, and recommended actions.
To Next Page
