To Next PageTo Next PageWhat to do if Makita DUR188L Trimmer has abnormal vibration?
If your Makita Trimmer is vibrating abnormally, stop the machine immediately! This could be because: * One end of the nylon cord has broken. Tap the nylon cutting head against the ground while it is rotating to cause the cord to feed. * The drive system is not working correctly. Ask your local authorized service center for repair.
What to do if my Makita DUR188L cutting tool and motor cannot stop?
If the cutting tool and motor of your Makita Trimmer won't stop, it indicates an electric or electronic malfunction. Immediately remove the battery and ask your local authorized service center for repair.
What to do if my Makita DUR188L Trimmer motor does not run?
If the motor of your Makita Trimmer doesn't run, there could be several reasons: * The battery cartridge might not be installed. Ensure the battery cartridge is correctly installed. * There might be a battery problem, such as undervoltage. Try recharging the battery. If recharging doesn't work, replace the battery. * The drive system may not be working correctly. In this case, ask your local authorized service center for repair.
Why does my Makita DUR188L not reach maximum RPM?
Your Makita Trimmer might not reach maximum RPM due to a few reasons: * The battery might be installed improperly. Ensure you install the battery cartridge as described in this manual. * The battery power could be dropping. Try recharging the battery, and if that doesn't help, replace it. * The drive system may not be functioning correctly. Contact your local authorized service center for repair.
What to do if my Makita DUR188L cutting tool does not rotate?
If the cutting tool of your Makita Trimmer doesn't rotate, stop the machine immediately. This could be due to: * A foreign object, like a branch, jammed between the guard and the nylon cutting head. Remove the foreign object. * The drive system not working correctly. In this case, ask your local authorized service center for repair.
Why does my Makita DUR188L motor stop running after a little use?
If your Makita Trimmer motor stops running after a short period, it could be due to: * Low battery charge. Recharge the battery, and if it's still not effective, replace the battery. * Overheating. Stop using the tool and allow it to cool down.
General
