How to fix no chain lubrication on my Makita Chainsaw?
If your Makita Chainsaw isn't lubricating the chain, the oil tank might be empty, the oil guide groove could be dirty, or the oil pump adjusting screw may be incorrectly adjusted. Refill the oil tank, clean the oil guide groove, and adjust the oil pump correctly.
Why does my Makita Chainsaw have warm start difficulties?
Warm start difficulties with your Makita Chainsaw are likely caused by a wrong carburetor adjustment. Adjust the carburetor to the correct settings.
How to fix insufficient power in my Makita EA3500F Chainsaw?
If your Makita Chainsaw has insufficient power, the air filter may be dirty, the carburetor adjustment may be wrong, the muffler could be clogged, the exhaust channel in the cylinder might be blocked, or the spark arrester screen could be clogged. Clean or replace the air filter, adjust the carburetor, and clear any blockages in the muffler, exhaust channel, and spark arrester screen as necessary.
Why is my Makita EA3500F engine hard to start?
There are several reasons why your Makita Chainsaw engine might be hard to start. It could be a malfunction in the fuel supply system, compression system, or a mechanical issue. Another reason might be a fault in the ignition system, a defective spark plug or spark plug cap, a carburetor issue, or a problem with the fuel line. Inspect and repair the fuel supply system and check the wiring. You should also check the ignition system, including the spark plug and wiring.
Why does my Makita EA3500F Chainsaw engine start, but die immediately?
If your Makita Chainsaw starts and then immediately dies, the cause may be a dirty suction head or carburetor, a defective tank venting system, an interrupted fuel line, a defective cable or combination switch, or a dirty decompression valve. To resolve this, clean the suction head and carburetor. Also, you should inspect and repair the fuel system and associated components.
What to do if the Makita EA3500F chain does not run?
If your Makita Chainsaw chain does not run, check the chain brake. The chain brake may be actuated.
How to fix warm start difficulties in my Makita Chainsaw?
To resolve warm start difficulties with your Makita Chainsaw, adjust the carburetor. This issue is often due to an incorrect carburetor adjustment.
General| Weight | 4.4 kg (9.7 lbs) |
|---|---|
| Chain Pitch | 3/8 inch |
| Bar Length | 35 cm (14") or 40 cm (16") |
| Oil Tank Capacity | 200 ml (6.8 oz) |
| Chain Gauge | 1.3 mm (0.05 inch) |
To Next Page
