What to do if Makita Chainsaw engine starts, but dies immediately?
If your Makita Chainsaw starts but dies immediately, it could be due to a wrong idling adjustment, or a dirty suction head or carburetor. Adjust the idling and clean the suction head or carburetor. Also, check the tank venting and fuel line, as a defective tank venting, interrupted fuel line, defective cable or combination switch could also be the cause.
How to fix insufficient power in Makita EA3500S Chainsaw?
If your Makita Chainsaw has insufficient power, the air filter may be dirty, the carburetor adjustment may be wrong, the muffler may be clogged, the exhaust channel in the cylinder may be clogged, or the spark arrester screen may be clogged. To resolve this, clean the air filter and muffler, and adjust the carburetor.
Why is my Makita EA3500S chain not running?
If the chain on your Makita Chainsaw isn't running, the chain brake might be activated. Check if the chain brake is in the 'off' position.
How to fix warm start difficulties with my Makita EA3500S Chainsaw?
If you're experiencing warm start difficulties with your Makita Chainsaw, it's likely due to an incorrect carburetor adjustment. Adjust the carburetor settings.
What to do if my Makita EA3500S engine starts, but dies immediately?
If your Makita Chainsaw engine starts but dies immediately, the idling adjustment might be wrong, or the suction head or carburetor could be dirty. Check and adjust the idling settings and clean the suction head or carburetor. Another possibility is a defective tank vent, an interrupted fuel line, a defective cable, or a defective combination switch. Inspect the tank vent and ensure the fuel line is not interrupted.
What to do if my Makita EA3500S has insufficient power?
If your Makita Chainsaw has insufficient power, it might be because the air filter is dirty, the carburetor adjustment is wrong, the muffler is clogged, the exhaust channel in the cylinder is clogged, or the spark arrester screen is clogged. Clean the air filter and check the carburetor adjustments.
How to fix insufficient power in Makita Saw?
If your Makita Saw has insufficient power, the cause might be a dirty air filter, incorrect carburetor adjustment, a clogged muffler, a clogged exhaust channel in the cylinder, or a clogged spark arrester screen. Clean or replace the air filter and muffler.
Why my Makita Chainsaw engine does not start?
If your Makita Chainsaw engine is not starting, begin by checking the ignition spark. Also inspect the wiring, and replace the spark plug or cap if defective. Ensure proper spark plug sealing. Adjust the combination switch and clean the carburetor if the combination switch is in Choke position, or if the carburetor is defective, or the suction head is dirty, or the fuel line is bent or interrupted. Finally, inspect the starter and engine parts, and replace defective components if the cylinder base packing ring or radial shaft packings are defective, or if the cylinder or piston rings are defective.
General| Weight | 4.6 kg |
|---|---|
| Chain Pitch | 3/8 inch |
| Bar Length | 35 cm |
| Fuel Tank Capacity | 0.48 liters |
| Oil Tank Capacity | 0.28 L |
| Power Rating | 1.7 kW |
| Chain Gauge | 0.050 inch |
To Next Page
