Makita EA3500SRDB - Cleaning the Air Filter Compartment;Fan Compartment; Cleaning the Cylinder Fins; Replacing the Suction Head; Replacing;Cleaning the Spark Arrester Screen

40
16
Replacing the suction head
The felt lter (16) of the suction head can become clogged.
It is recommended to replace the suction head once every
three months in order to ensure unimpeded fuel ow to the
carburetor.
To remove the suction head for replacement, pull it out
through the tank ller neck using a piece of wire bent at one
end to form a hook.
15
15
12
11
14
Replacing/cleaning the spark arrester screen
The spark arrester screen should be checked and cleaned
regularly.
Unscrew 3 screws (11) and remove the upper half of the
mufer (12) and then the spark arrester screen (14).
Caution: Do not use sharp or pointed objects for screen
cleaning. Damaged or misformed screen wires may result.
Reassemble the spark arrester screen and the upper mufer
half, and then tighten the screws.
Cleaning the air lter compartment/fan
compartment
Remove cover.
Remove the fan housing.
CAUTION: To prevent eye injury, always wear eye
protection when cleaning the lter with compressed air!
The entire area (15) can now be brushed clean or cleaned
with compressed air.
Cleaning the cylinder ns
A bottle brush can be used to clean the cylinder ns.