To Next PageTo Next PageWhat to do if the cutter blade does not stop immediately on my Makita Lawn and Garden Equipment?
If the cutter blade on your Makita Lawn and Garden Equipment does not stop immediately, stop the engine immediately. This could be due to high idling rotation, which needs adjustment. Also, check if the throttle wire is detached and attach it securely.
Why does my Makita EM2650LH engine stop soon or not increase speed?
If the engine of your Makita Lawn and Garden Equipment stops soon after starting, or if the engine speed does not increase, several factors could be the cause. Make sure that you perform a sufficient warm-up operation. Check that the choke lever is set to “OPEN” if the engine is warmed up. A clogged fuel filter or a contaminated air cleaner can also cause these issues, so clean them.
What to do if my Makita Lawn and Garden Equipment vibrates abnormally?
If the main unit of your Makita Lawn and Garden Equipment vibrates abnormally, stop the engine immediately. This could be due to a broken, bent, or worn cutter blade, which should be replaced. Check if the cutter blade-tightening nut is loosened and tighten it securely. Also, make sure the convex part of the cutter blade and cutter blade support fitting are securely attached.
General| Brand | Makita |
|---|---|
| Model | EM2650LH |
| Category | Lawn and Garden Equipment |
| Language | English |
Covers general safety rules, intended use, personal protective equipment, and user responsibility for safe operation.
Details essential safety checks and procedures required before starting the brushcutter and string trimmer.
Outlines crucial safety measures and precautions to be taken during the refueling process to prevent accidents.
Covers safe operating practices, including working conditions, cutting techniques, and avoiding hazards.
Explains the phenomenon of kickback and provides essential methods to prevent it, especially when using metal blades.
Provides essential information on first aid procedures and necessary details to communicate in case of an accident.
Provides step-by-step instructions for correctly mounting the handles and other essential components onto the machine.
Details the correct procedures for installing the protective guards for both EM2650UH and EM2650LH models.
Explains how to properly mount the cutter blade or the nylon cutting head onto the brushcutter.
Guides users on inspecting and refilling the engine oil to the correct level before operation.
Covers safe practices for handling, storing, and refueling the machine with gasoline.
Details how to attach and detach the shoulder strap for proper balance and emergency release.
Explains the correct methods for starting the engine, operating the controls, and safely stopping the machine.
Provides specific instructions for starting the engine, especially in difficult conditions like cold weather.
Guides users on how to check and adjust the engine's low-speed idling rotation.
Explains the operation and maintenance of the nylon cutting head, including effective cutting areas.
Provides detailed instructions on how to replace the nylon cord in the cutting head.
Details the essential daily checks and maintenance tasks to be performed after each use for longevity.
Provides instructions for replacing engine oil and cleaning or replacing the air cleaner element.
Covers cleaning and replacement procedures for the fuel filter and fuel pipe to ensure proper fuel delivery.
Details checking the spark plug gap and supplying grease to the gear case for maintenance.
Lists common malfunctions, their probable causes, and recommended remedies for quick issue resolution.
Explains emission compliance periods and the Air Index system for the engine.
Details the specific emissions control system warranty requirements and coverage for California.
Outlines the federal emission component defect warranty coverage applicable in all states except California.
Guides users on how to obtain warranty service, including required documentation and contact information.
Clarifies warranty terms, maintenance responsibilities, and claim procedures related to the emission control system.
