Installing or removing bull point
or
other bits (cold chisel, etc.)
CAUTION
:
Always be sure that the tool
is
switched off and unplugged before installing or removing
the bit.
Press in the tool retainer and turn
it
until
the red dots on the tool retainer and the
tool holder are aligned.
Release
the tool
retainer.
Insert the bit into the tool holder
as
far
as
it will go. Press in the tool retainer and
turn
it
a
full
180
degrees. Then release
it
to secure the bit.
1
-
Red
dot
(Tool
holder)
Red
dot
(Tool
retainer)
~
Tool
retainer
II,
To
remove the bit, follow the installation procedures in reverse.
Side grip (auxiliary handle)
The side grip swings around to either side,
allowing easy handling of the tool in any
position. Loosen the side grip
by
turning
it counterclockwise, swing
it
to the desired
position and then tighten
it
by turning
clockwise.
5
To Next Page
Loading...
