Makita HM1213C Technical Information

Wiring diagram
P 17/ 17
Connector
for connecting
to Controller
Lead wire holder
Lead wire holder
covered with Sponge
sheet
Fix Lead wires with
Sponge sheet and
Lead wire holder.
Wiring to Switch
Wiring in Handle
Connect Insulated connector to Switch
so that the clamped portions are in the
width of Switch.
If the clamped portions of insulated connectors
were out of width of Switch, they would inter-
fere in installing the switch as shown below.
Switch
Switch
Switch
The following Lead wires have
to be put on the Lead wire (thin,
black) connecting Switch and
Controller, in this Lead wire holder.
* Lead wire (thick, black) connecting
Switch and Terminal block,
* Lead wire (thick, white) connecting
Switch and Controller
Insulated connector
Expand the Lead wires between
Switch and Lead wire holder.
Fix Lead wires with
Lead wire holder.
Fig. D-3
Fig. D-4
The clamped
portions
face inside.
The clamped
portions
face outside.
the width of
Switch
the width of
Switch

Makita HM1213C Specifications

General

Input power	1500 W
Impact energy (max)	18.6 J
Vibration level (chiseling)	7 m/s²
Toolholder	18 mm
Impact rate	1900 bpm
Product color	Black, Blue

Weight and Dimensions

Depth	149 mm
Width	576 mm
Height	265 mm
Weight	10800 g