Need help?Do you have a question about the Makita JN1601 and is the answer not in the manual?
General| Ergonomic grip | Yes |
|---|---|
| Connected load | 550 W |
| AC input voltage | 220 V |
| AC input frequency | 50 - 60 Hz |
Weight and Dimensions| Weight | 1600 g |
|---|
Symbols used for the equipment and their meaning.
The tool is intended for cutting sheet steel and stainless sheet steel.
Connect to a power supply of the same voltage, single-phase AC.
Sound pressure level and acceleration values.
Product compliance with standards and directives.
Safety precautions for the operating environment and presence of others.
Precautions regarding power supply, cords, and environmental conditions.
Staying alert, using safety gear, and maintaining balance.
Proper usage, maintenance, and handling of the power tool.
Specific safety instructions for operating and handling the tool.
How to rotate the die holder to different positions.
Material thickness limits indicated by die holder groove.
Using the notch on the die holder to guide cuts.
How to operate the power switch.
Steps for replacing the punch and die set.
Apply machine oil to cutting line for longer service life.
How to hold and move the tool during cutting.
Procedure for making cutouts by creating an initial hole.
Hold tool parallel to grooves with cutting head at 90° to surface.
How to check and replace worn carbon brushes.
List of recommended accessories and caution on using others.
To Next Page
