To Next Page

To Previous Page

7 ENGLISH

►1. Filter 2.Prelter

Reassembly

Putonthelterfullyinpositiononthecleanerunit.

►1. Filter

NOTICE: Make sure the lter is put on straight

without being peeled back.Ifthelterisputon

incorrectly as illustrated, dust will get into the motor

housing, and cause a motor failure.

►1. Filter

Installtheprelter.Atthistime,makesuretotwistthe

preltersothatthesecuringlipisrmlylockedinthe

cleaner unit.

►1.Prelter2. Securing lip

Installthecapsule.Alignthemarkonthecapsulewith

themarknearthehandleandthenrmlytwistthecap-

sule in direction of the arrow until it is secured.

►1. Capsule 2. Handle 3. Mark

NOTE: Always remove dust ahead of time, as the

suction power will be reduced if there is too much

dust in the cleaner.

NOTICE: Always be sure to check that both the

lter and prelter are loaded correctly prior to

using the cleaner.Iftheyarenotloadedcorrectly,

dust will get into the motor housing, and cause a

motorfailure.Ifthefollowingexamplesoccur,thelter

andprelterarenotloadedcorrectly.Reloadthem

correctly to rectify problem.

Makita LC06 User Manual

Questions and Answers: