Makita LD060P User Manual

the stop bracket with a little force to the right
side; the stop bracket can now be completely
unfolded. See drawing {E}.
A CAUTION:
Make sure that when measuring from the
unfolded endpiece, the measuring reference is set to
"End piece"!
lx briefly: the next measurement is taken from
the front edge.
jjjj 2x briefly: the measurement is taken from the
unfolded end piece.
After one measurement, the reference returns auto¬
matically to the default setting (rear reference).
lx long: the measurements are taken with the
front as reference until a new measuring refe¬
rence is set
2x long: the measurements are taken from the
unfolded end piece until a new measuring refe¬
rence is set.
See drawing {F}.
Measuring
Single Distance Measurement
lx briefly: the laser is activated.
lx briefly: a distance measurement is taken.
Makita LD060P
The result is displayed immediately.
GB
Continuous measurement
Distances can be measured with this function
lx long: a "beep" is sounded.A continuous
measurement is started.
ON
lx briefly: the continuous measurement is
stopped.
The last measured value is displayed in the summary
line.
Minimum-/Maximum-Measuring
This function enables determining the minimum or
maximum distance from a specific measuring point,
e.g. the determination of room diagonals (maximum
value) or horizontal distance (minimum value).
Switching on continuous measurement (see above).
The corresponding maximum and minimum values are
displayed.
Functions
Addition / Subtraction
Distance Measurement.
lx briefly: the next measurement is added to
the previous one.
Measuring

Makita LD060P Specifications

General

Brand	Makita
Model	LD060P
Category	Measuring Instruments
Language	English