To Next PageTo Next Page
Need help?Do you have a question about the Makita LH1040 and is the answer not in the manual?
General| Input power | 1650 W |
|---|---|
| Cable length | 2.5 m |
| Power source | AC |
| Idle speed (max) | 4800 RPM |
| Blade bore | 15.88 mm |
| Blade diameter | 260 mm |
| Saw blade type | Tungsten carbide-tipped (TCT) |
| Dust bag included | Yes |
| Cutting capacity 0° | 93 mm |
| Cutting capacity 45° miter | 53 x 95 mm |
Weight and Dimensions| Depth | 530 mm |
|---|---|
| Width | 476 mm |
| Height | 535 mm |
| Weight | 14300 g |
Identifies and lists all parts of the tool using numbered diagrams.
Details model, blade size, cutting capacities, weight, and power.
Essential safety warnings applicable to all power tools.
Specific safety precautions for miter and table saw modes.
Steps for installing auxiliary plate, holders, and bench mounting.
Explains the function and operation of the blade guard.
How to adjust cutting capacity, miter, and bevel angles for precision.
Operating the switch, lamp, and adjusting the top table level.
Procedures for installing/removing blades and adjusting the riving knife.
Steps to install and properly adjust the rip fence for safe cutting.
Methods to secure workpieces and details on sub-fence use.
Information on installing and using optional vertical and horizontal vises.
Guidance on performing various angle cuts accurately.
Techniques for press cuts and safety for cutting aluminum extrusions.
Instructions for using the tool in table saw (bench) mode.
How to use work helpers for safer cutting of small or narrow workpieces.
Safe practices for ripping cuts and carrying the tool.
Routine maintenance, brush replacement, and angle calibration.
List of recommended optional accessories for enhancing tool functionality.
Technical data on noise, vibration, and EU conformity.
