Makita LS0714N User Manual

8
SPECIFICATIONS
Model LS0714 / LS0714F / LS0714FL / LS0714L
Blade diameter 190 mm
Blade body thickness 1.3 mm - 2.0 mm
Hole (arbor) diameter 20 mm
Max. Miter angle Left 47°, Right 57°
Max. Bevel angle Left 45°, Right 5°
Max. Cutting capacities (H x W) with blade 190 mm in diameter.
Bevel angle
Miter angle
45° (left) 0° 5° (right)
* 45 mm x 265 mm Note 1 * 60 mm x 265 mm Note 1 -----
0°
40 mm x 300 mm 52 mm x 300 mm 40 mm x 300 mm
* 45 mm x 185 mm Note 2 * 60 mm x 185 mm Note 2
45° (left and right)
40 mm x 212 mm 52 mm x 212 mm
-----
* 60 mm x 145 mm Note 3
57° (right) -----
52 mm x 163 mm
-----
(Note)
* mark indicates that a wood facing with the following thickness is used.
1: When using a wood facing 20 mm thick.
2: When using a wood facing 15 mm thick.
3: When using a wood facing 10 mm thick.
No load speed (min
-1
) 6,000
Laser Type (LS0714FL/L) Red Laser 650 nm,
1 mW (Laser Class 2)
Dimensions (L x W x H) 670 mm x 430 mm x 458 mm
Net weight LS0714: 13.1 kg, LS0714F: 13.4 kg, LS0714FL: 13.7 kg, LS0714L: 13.5 kg
• Due to our continuing program of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
END228-1
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･ Read instruction manual.
･ DOUBLE INSULATION
･ To avoid injury from flying debris, keep
holding the saw head down, after
making cuts, until the blade has come to
a complete stop.
･ When performing slide cut, first pull
carriage fully and press down handle,
then push carriage toward the guide
fence.
･ Do not place hand or fingers close to the
blade.
･ For your safety, remove the chips, small
pieces, etc. from the table top before
operation.
･ Always set SUB-FENCE to left position
when performing left bevel cuts. Failure
to do so may cause serious injury to
operator.
･ To loosen the bolt, turn it clockwise.
･ Never look into the laser beam. Direct
laser beam may injure your eyes.
･ Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of the European Directive,
on Waste Electric and Electronic
Equipment and its implementation in
accordance with national law, electric
equipment that have reached the end of
their life must be collected separately
and returned to an environmentally
compatible recycling facility.

Makita LS0714N Specifications

General

Brand	Makita
Model	LS0714N
Category	Saw
Language	English