Need help?Do you have a question about the Makita LS0815F and is the answer not in the manual?
Identifies symbols used for the equipment and their meanings for safe use.
Describes the tool's purpose for accurate straight and miter cutting in wood.
Information on connecting the tool to a power supply and its double insulation.
Details the A-weighted noise levels (sound pressure and power) determined by standards.
Specifies the total vibration value and emission levels determined by standards.
Instructions for securing the miter saw to a stable surface for safe operation.
Details on the automatic blade guard operation, maintenance, and warnings for safe use.
How to adjust kerf boards to minimize workpiece tear-out during cuts.
Adjusting the tool for optimal cutting capacity with a 216 mm saw blade.
How to adjust the stopper arm to set the lower limit position of the blade.
Procedure for setting the desired angle on the miter scale.
Procedure for setting the desired angle on the bevel scale.
How to lock or unlock the slide pole for secure positioning.
Operation of the lock-off button and switch trigger for starting and stopping the tool.
Explanation of the smooth start-up function that limits torque.
Operation and precautions for the laser guide system on specific models.
How to operate the integrated work light for illumination.
Location and use of the integrated socket and hex wrench.
Step-by-step guide for safely replacing the saw blade.
Information on attaching and using the dust collection bag.
Critical steps to properly secure workpieces for safe and accurate cuts.
How to adjust the sliding fences for proper workpiece alignment.
How to install and use optional workpiece holders for horizontal work.
Method for making cuts on smaller workpieces.
Technique for cutting wider workpieces using the slide function.
Instructions for performing miter cuts using angle adjustments.
Procedure for making angled cuts using the bevel adjustment.
How to perform cuts combining miter and bevel angles.
Specific techniques for cutting moldings with the saw.
How to measure and set up workpieces for cutting moldings accurately.
Guidelines for safely cutting aluminum extrusions with the saw.
How to attach and use wood facing for splinter-free cuts.
Procedure for making parallel grooves in a workpiece.
Safe methods for transporting the miter saw.
Steps to align the miter scale and pointer for accurate angle settings.
Steps to align the bevel scale and pointer for accurate angle settings.
Procedure for inspecting and replacing worn carbon brushes.
Recommended cleaning and lubrication steps after operating the tool.
To Next Page
General
