Need help?Do you have a question about the Makita LS1020 and is the answer not in the manual?
General| Blade Diameter | 10 inch |
|---|---|
| Arbor Size | 5/8 inch |
| Motor | Direct Drive |
| No Load Speed | 4, 600 RPM |
| Weight | 31.5 lbs |
| Voltage | 120 V |
| Type | Miter Saw |
| Max Cutting Capacity (Horizontal) | 12 inch |
| Motor Power | 15 amps |
| Max Cutting Depth at 90° | 3.5 inches |
| Max Cutting Depth at 45° | 2.5 inches |
Read manual for applications, limitations, and potential hazards.
Keep guards in place and remove adjusting keys/wrenches before operation.
Maintain a clean, well-lit area, keep children away, and avoid dangerous environments.
Use the correct tool, don't force it, and wear appropriate safety apparel.
Always use safety glasses; consider a face or dust mask for dusty operations.
Secure work with clamps or a vise; maintain proper footing and balance.
Maintain tools, disconnect before servicing, and prevent unintentional starting.
Ensure voltage matches the tool's nameplate to avoid injury or damage.
Check blade for cracks; ensure guards are in place and flanges are correct.
Secure turn base, clear table, remove nails, and ensure shaft lock release.
Hold handle firmly, keep hands clear of blade, and avoid overreaching.
Run tool before cutting, wait for full speed, stop if abnormal, and don't lock trigger.
Don't abuse cord; shut off power before servicing or adjusting tool.
Used to lock the handle in the lowered position for carrying and securing the turn base.
Bolt the tool to a level and stable surface using provided mounting holes.
Instructions on how to safely remove and install the saw blade using specified tools.
Never defeat or remove the safety cover; keep it clean and functional for safe operation.
Use the dust bag for clean cutting operations and easy dust collection.
Explains lock-off button for safety and how to start/stop the tool.
Describes how to cut a groove in the kerf board before use for accurate cutting.
How to adjust depth setting for maximum cutting capacity considering blade wear.
How to set and lock the desired miter angle using the scale and latch spring.
Describes how to use the vise to grip workpieces securely for cutting operations.
Steps for making cuts, including blade speed, handle pressure, and stopping.
Prevents smaller cutting scraps from jamming inside the blade case.
Attaching wood facing to the guide fence for splinter-free cuts.
How to adjust the hex lock nut for smooth handle movement and cutting accuracy.
How to align the blade and guide fence for square cuts.
How to install holders and set plate for holding long workpieces.
Using the set plate to cut multiple pieces to the same length.
How to lock the handle and secure the turn base for safe transport.
Steps to check, replace, and maintain carbon brushes for tool longevity.
List of recommended accessories like dust bag, socket wrench, lock-off button.
Details on different saw blades for rip, cross-cut, and smooth cuts.
Details the warranty policy, coverage, and limitations for the Makita tool.
To Next Page
