Need help?Do you have a question about the Makita PH05 and is the answer not in the manual?
Guidelines for maintaining a safe operating environment.
Precautions to prevent electric shock during operation.
Measures to protect the operator from injury.
Use the correct tool for the job to ensure safety and efficiency.
Disconnect power source/battery before any adjustments or accessory changes.
Regular checks and repairs ensure safety and reliability.
Use specified chargers and designated battery packs for safety.
Avoid shorting, dropping, or using damaged batteries to prevent hazards.
Charge battery when power is noticeably less for optimal service life.
Never recharge an already full battery to prevent shortening its service life.
Avoid terminal contact with conductive materials, metal objects, or water.
Never incinerate or drop batteries; follow local disposal regulations.
Instructions for correctly inserting and removing the battery.
The tool automatically stops when drawing abnormally high current.
Operation stops when battery capacity is too low; requires recharging.
Pull trigger to start; speed increases with pressure. Tool stops when released.
Tool stops quickly after trigger release; seek service if inconsistent.
Always verify rotation direction before operating the tool.
Use reversing switch only after the tool has completely stopped.
Ensure lever is fully in position '1' or '2'; avoid halfway settings.
Align the ring correctly to desired mode (Drilling, Hammer Drilling, Screwdriving).
Adjust torque using the ring; test screws for proper level.
Securely insert bits by turning the sleeve clockwise and remove counterclockwise.
Attach the hook to the housing for temporary hanging.
Insert battery fully until the red indicator is not visible.
Reduce load or stop tool if speed decreases significantly to prevent damage.
Set the adjusting ring to the proper torque level for the work.
Insert driver bit straight into screw head to avoid damage.
Turn action mode ring to the hammer drilling symbol.
Use light pressure, keep tool in position, and clear chips from clogged holes.
Turn adjusting ring to the drill symbol before proceeding.
Use wood drills with guide screws for easier drilling.
Use center-punch, cutting lubricant (except iron/brass), and firm grip.
Switch off, set neutral, turn mode ring to screwdriver symbol.
Remove bit, turn off tool, and wait for stop before placing in holster.
Ensure tool is OFF and battery is removed before inspection or maintenance.
Repairs and adjustments should be done by Authorized/Factory Service Centers.
Use only recommended accessories for safety and stated purpose.
Covers defects in workmanship/materials for one year; excludes abuse, alterations, normal wear.
Dust from construction may contain cancer-causing chemicals; use ventilation and PPE.
To Next Page
General
