Makita PLM5121N2 - User Manual

Other manuals for Makita PLM5121N2

Questions and Answers

J
Jonathon MillsAug 6, 2025
What to do if my Makita Lawn Mower engine is difficult to start or loses power?
- D
  Dr. Cody Merritt MDAug 7, 2025
  If your Makita Lawn Mower engine is difficult to start or loses power, the issue might stem from several causes. Start by draining the fuel tank to remove any dirt, water, or stale fuel, then clean the tank and refill it with clean, fresh fuel. Check the fuel tank cap's vent hole to ensure it's not plugged; clean or replace the cap if necessary. Also, a dirty air cleaner element can cause these problems, so clean it.
B
bergmeghanAug 11, 2025
Why is my Makita PLM5121N2 engine overheating?
- T
  thomascollinsAug 11, 2025
  If your Makita Lawn Mower engine is overheating, it may be due to restricted cooling airflow. Remove any debris from the slots in the shroud, blower housing, and air passages to ensure proper ventilation. Also, make sure the spark plug is the correct type and that the cooling fins are properly installed on the engine. Using an incorrect spark plug can also cause overheating.
L
leemarkAug 15, 2025
Why does my Makita Lawn Mower engine operate erratically?
- E
  Elizabeth MasseyAug 15, 2025
  If your Makita Lawn Mower engine is operating erratically, a likely cause is a defective spark plug, which should be replaced. Ensure the new plug is correctly gapped. Another potential cause is an incorrect spark plug gap; adjust the gap between the electrodes to be between 0.7 and 0.8 mm. Also, a dirty air cleaner element can cause the engine to run erratically, so clean it.
J
Jeffery SnowAug 20, 2025
Why is my Makita PLM5121N2 Lawn Mower vibrating abnormally?
- M
  Marcus ThompsonAug 20, 2025
  If your Makita Lawn Mower is vibrating abnormally, it could be due to a loose or unbalanced cutting assembly. Start by tightening the blade. If the vibration persists, the blade may be unbalanced and needs to be balanced.
R
Ricardo ParkerAug 25, 2025
How to resolve poor idling in my Makita PLM5121N2 Lawn Mower?
- R
  Robert BarnesAug 25, 2025
  Poor idling in a Makita Lawn Mower can often be traced back to a dirty air cleaner element, so cleaning it is a good first step. Additionally, check the air slots in the engine shroud and remove any debris blocking them. Also, inspect the cooling fins and air passages under the engine blower housing, and clear away any obstructions.
K
Kathleen BrandtAug 28, 2025
What causes a Makita Lawn Mower engine to skip at high speed?
- B
  Briana HarrisonAug 28, 2025
  If your Makita Lawn Mower engine skips at high speed, it may be because the gap between the spark plug electrodes is too close. Adjust the gap between the electrodes to the specified range of 0.7 to 0.8 mm.
E
Elizabeth LucasNov 1, 2025
How to fix a Makita PLM5121N2 when the engine does not start?
- P
  pearsonkennethNov 2, 2025
  If your Makita Lawn Mower's engine won't start, several factors could be at play. First, check that the throttle chock is correctly positioned for the current conditions and adjust if necessary. Ensure the fuel tank isn't empty; if it is, refill it. Inspect the spark plug: tighten it to 25-30 Nm if loose, ensure the spark plug wire is securely connected, and verify the gap between electrodes is between 0.7 and 0.8 mm. If the spark plug is defective, replace it. Also, a dirty air cleaner element can prevent starting, so clean it. If the carburetor is flooded with fuel, remove the air cleaner element and pull the starter rope until the carburetor clears itself, then reinstall the air cleaner element. If none of these steps work, the ignition module may be faulty, and you should contact a ser...

Makita PLM5121N2 Specifications

General

Type	Walk behind lawn mower
Cutting width	510 mm
Grass catcher	-
Product color	Black, Blue
Uncertainty K	1.5 m/s²
Number of speeds	1
Number of wheels	4 wheel(s)
Rotational speed	2600 RPM
Maximum lawn area	2200 m²
Oil tank capacity	0.47 L
Sound power level	98 dB
Fuel tank capacity	1 L
Standard deviation	3 dB
Vibration emission	2.3 m/s²
Engine displacement	163 cm³
Rear wheels diameter	280 mm
Sound pressure level	79.2 dB
Front wheels diameter	200 mm
Recommended lawn area	- m²
Maximum cutting height	70 mm
Minimum cutting height	25 mm
Grass collecting volume	- L
Number of height positions	5
Cutting clearance adjustment	Yes
Cutting clearance adjustment type	Stepped
Power source	Gasoline