Makita PLM5600 User Manual (English)

Questions and Answers:

J
john72Jul 26, 2025
What to do if my Makita PLM5600 Lawn Mower engine is difficult to start or loses power?
- A
  Anthony BlackJul 26, 2025
  If your Makita Lawn Mower engine is difficult to start or loses power, it could be due to several reasons. There might be dirt, water, or stale fuel in the tank. Drain the fuel and clean the tank, then fill it with clean, fresh fuel. The vent hole in the fuel tank cap could be plugged, so clean or replace the fuel tank cap. Also, a dirty air cleaner element can cause this issue, so clean the air cleaner element.
N
nelsonjacquelineJul 30, 2025
Why does my Makita PLM5600 Lawn Mower engine idle poorly?
- R
  rebeccashawJul 30, 2025
  If your Makita Lawn Mower engine idles poorly, the air cleaner element might be dirty, so clean the air cleaner element, referring to the ENGINE OWNERS MANUAL. Additionally, air slots in the engine shroud could be blocked, so remove any debris from the slots. Cooling fins and air passages under the engine blower housing might also be blocked, so remove debris from the cooling fins and air passages.
R
rebekahstephensAug 4, 2025
Why does my Makita PLM5600 engine skip at high speed?
- L
  leerobertAug 4, 2025
  If your Makita Lawn Mower engine skips at high speed, the gap between the electrodes of the spark plug might be too close. Set the gap between the electrodes at 0.7 to 0.8 mm.
H
Helen SalinasAug 13, 2025
Why is my Makita PLM5600 engine overheating?
- B
  Brett GlassAug 13, 2025
  If your Makita Lawn Mower engine is overheating, the cooling air flow might be restricted. Remove any debris from the slots in the shroud, blower housing, and air passages to ensure proper ventilation. Also, the incorrect spark plug could be the cause. Install an RJ19LMC spark plug and ensure the cooling fins are properly attached to the engine.
E
Eduardo ReyesAug 17, 2025
Why is my Makita Lawn Mower vibrating abnormally?
- A
  Alison MendozaAug 17, 2025
  If your Makita Lawn Mower is vibrating abnormally, the cutting assembly might be loose, so tighten the blade. Alternatively, the cutting assembly could be unbalanced, so balance the blade.
G
glennrandyAug 21, 2025
What to do if my Makita PLM5600 engine operates erratically?
- A
  Angel SmithAug 21, 2025
  If your Makita Lawn Mower engine is operating erratically, the spark plug might be defective, so install a new, correctly gapped plug, referring to the ENGINE OWNERS MANUAL. The spark plug gap could also be incorrect; set the gap between electrodes at 0.7 to 0.8 mm. Additionally, a dirty air cleaner element can cause this issue, so clean the air cleaner element, referring to the ENGINE OWNERS MANUAL.