To Next Page

To Previous Page

6 ENGLISH

Switch action

►1. Switch trigger

CAUTION: Before installing the battery car-

tridge into the tool, always check to see that the

switch trigger actuates properly and returns to

the "OFF" position when released.

Tostartthetool,simplypulltheswitchtrigger.Tool

speed is increased by increasing pressure on the switch

trigger. Release the switch trigger to stop.

NOTE:Thetoolautomaticallystopsifyoukeeppull-

ing the switch trigger for about 6 minutes.

Lighting up the front lamp

CAUTION: Do not look in the light or see the

source of light directly.

►1. Lamp

►1. Button

Pulltheswitchtriggertoturnonthelamp.Toturnoff,

releaseit.Thelampgoesoutapproximately10seconds

after releasing the switch trigger.

Tokeepthelampoff,turnoffthelampstatus.Toturnoff

thelampstatus,rstpullandreleasetheswitchtrigger.

Andthenpressthebutton

for one second within 10

seconds.

Toturnonthelampstatusagain,pressthebuttonagain

similarly.

NOTE:Toconrmthelampstatus,pullthetrigger.

Whenthelamplightsupbypullingtheswitchtrigger,

thelampstatusisON.Whenthelampdoesnotcome

on, the lamp status is OFF.

NOTE:Whenthetoolisoverheated,thelightashes

foroneminute,andthentheLEDdisplaygoesoff.In

this case, cool down the tool before operating again.

NOTE:Useadryclothtowipethedirtoffthelensof

the lamp. Be careful not to scratch the lens of lamp, or

it may lower the illumination.

Reversing switch action

►1. Reversing switch lever

Makita TD111DSAJ User Manual

Questions and Answers: