11
④ Monitor LED Displays the memory unit status. When the memory unit is off, it does not
light up. Although the memory unit turns on, when it does not light up, the
battery is exhausted. Please recharge it.
（Please recharge the battery for the memory unit with Lithium ion
battery.)
After the memory unit turning on, and after measurement (from lighting up
Green LED to after passing the maximum measurement time), if you don't
operate at all, the memory unit will turn off automatically after five
minutes.
● LED display when a memory unit is not connecting to a PC
The measurement is possible.
Lighting up
in blue
When you press the power switch, start measurement.
During measurement Lighting up
in green
Record the tem. data to the memory unit.
The measurement is impossible. Lighting up
in red
Overheating. the temp. inside reached over 80℃ during
measurement, or it was over 80℃ when turning on the
memory unit. It will keep lighting up until connection to a
PC or turning it on again.
The measurement is impossible.
Blinking in
Red
The temp. inside is 35～80℃, or it was 35～80℃ when
turning on the memory unit. It will keep blinking until
connection to a PC or turning it on again.
Blinking in
Yellow and
Light blue
Failed to initialize the Bluetooth module.
Press the button while the LED is flashing to initialize it
forcibly.
*1 LED does not flash in red during the measurement.
The LED will blink in red by the connection to PC or turning on again.
When the temperature inside is over 80℃, the LED will light up in red
immediately. If it light up in red during measurement, it does not blink in
red when the temperature inside get from 35～80℃. It will blink in red by
the connection to PC or turning on again.
To Next Page
Loading...