5
Precautions for use
● When taken out of the furnace, the memory unit is very hot. Wear thick cotton gloves or the like,
and use care not to get burned.
● Before starting measurement, be sure to fully cool down the memory unit (to the room temperature).
● When storing the memory unit, be sure to turn OFF the internal power switch.
● If thermocouples are not set to all the channels, measurement error may result. If there is any
channel which is not in use, connect a short pin to the channel. If breaking occurs in any channel
during measurement, memory may become incorrect. In such a case, replace the thermocouple,
and perform measurement again.
● We will assume no responsibility for any trouble that may be caused by the replacement of
rechargeable battery.
● This device is designed to operate on AAA batteries, unable to use with AC adapter.
● When the device is turned on and not measuring, power is automatically turned off after five
minutes.
● Excessive heating of the memory unit can cause trouble. When measuring, use the memory unit
under the condition where the internal temperature will not exceed 80℃.
● The heat-resistant case has a ball catch for locking, on the opposite side of which is the rotating axis
of the thermocouple connector. When opening the heat-resistant case, lift up the opposite end of
the connector.
● There is a clock function inside RCX-S memory unit, supplied date and time during temperature
measurement.
Remove a battery to stop the clock.
Since a battery is disconnected before shipment, please set the clock before use.
For setting, connect the memory unit to a PC, check [Time adjustment] in [Unit Settings] in TMR-1
software and press [OK] button, and adjust the internal clock of the memory unit to the date and
time displayed on TMR-1 software. For more information, please refer to the TMR-1 instruction
manual.
* Be sure to set a watch so that TMR-1 can take in data.
To Next Page
Loading...