Malcom RCX-1 - 2 Handling Method; Wireless Connection to a PC by Bluetooth; Connection to a PC with USB Cable

14
II Handling Method
II-1 Wireless Connection to a PC by Bluetooth
For connection to Bluetooth, please refer to the TMR-1 instruction manual.
＊ In order to use Bluetooth, connect the memory unit to a PC, select [Using the Bluetooth] in [Unit
Settings] – [Radio mode] in TMR-1.And check [Use the Bluetooth to communicate measurement
data] in [PC Settings] – [Wireless communication] in TMR-1.
II-2 Connection to a PC with USB cable
When communicating a memory unit and PC with a USB cable, connect a supplied USB cable to the
connector on the side of the memory unit
* When not connected Bluetooth, connect the memory unit to a PC, set [Using the Bluetooth] in [Unit
Settings]– [Radio mode] and remove [Use the Bluetooth to communicate measurement data] check in
[PC Settings] - [Wireless communication] – [Use the Bluetooth to communicate measurement data] in
TMR-1.
The reason to set to [Using the Bluetooth] in [Radio mode] is that the memory unit can not communicate
when using Bluetooth and it is not set. Regardless of the use of Bluetooth and unused, set [Radio mode]
to [Using the Bluetooth].