SPECIFICATIONS:
BUILT-IN 12V 10AH RECHARGEABLE LEAD ACID BATTERY.
INSTANT BATTERY JUMP STARTER.
DUAL 12 VDC COVERED OUTPUT PORTS.
USB POWER SUPPLY OUTPUT PORT RATED AT 5V - 2100mA.
200 WATT CONTINUOUS/400 WATT PEAK POWER INVERTER
WITH 120 VAC COVERED OUTLET.
260PSI AIR COMPRESSOR WITH NEEDLE DIAL GAUGE.
ULTRA BRIGHT WHITE LED CONVENIENCE.
COMPACT AND PORTABLE SIZE WITH RUBBERIZED HANDLE.
NOZZLE ADAPTORS FOR INFLATABLES.
AC & DC CHARGERS ARE INCLUDED.
CHARGING BOOST 200 INSTRUCTIONS:
CAUTIONS
Prior to charging this device, read and understand all the related instruction indicated below.
Fully charge the Boost 200 unit when the Battery Status Needle Dial reads below 12 VDC.
This product may arrive partially charged from the factory. It is highly recommended to fully
charge the Boost 200 unit after purchase and before using for the fist time.
Make certain that all ON/OFF Power Switches are set in the OFF position.
Do not charge the Boost 200 Power Supply near flammable material, open flame or any
location which accumulate flammable fumes.
Make certain the electrical outlet located in a potentially wet or moist area that is to be used
to charge this device, is protected by a Ground Fault Circuit Interrupter (GFCI).
Make sure that both booster clamps are securely placed in their designated storage
compartments when not in use and during the charging period.
A. AC Charging At Home with 110 Volt Charger
1. Keep the Main Booster Power Switch in OFF position while charging.
2. Insert the AC charger round plug into the Boost 200 Charging Port.
3. Connect the 110 Volt AC Charger into the 110 Volt AC home receptacle.
4. Fully charge the Boost 200 according to the following schedules:
First time charge: 32 hours
Recharge and subsequent charge: 24 hours
5. Unplug the AC charger from the 110 Volt receptacle first and then remove the round plug from the
Boost 200 Charging Port.
B. DC Charging In Your Vehicle with 12 Volt Charger
1. Keep the Main Booster Power Switch in OFF position while charging.
2. Insert the 12 Volt DC Charger round Plug into the Boost 200 Charging Port.
3. Connect the 12 Volt DC Charger Plug into the vehicle cigarette lighter or 12 Volt accessory port.
4. Fully charge the Boost 200 internal battery for 6 hours while the vehicle engine is running.
5. Unplug the DC charger from the 12 Volt DC plug from the vehicle cigarette lighter port first and then
remove the round plug from the Boost 200 Charging Port.
INTERNAL BATTERY CHARGE LEVEL:
Turn the Main Booster Power Switch to the ON position to determine the unit internal battery
charge level prior to each use.
The Battery Charge Status Gauge Needle will indicate the battery charge level.
Gauge needle in Red Zone: Low Battery Charge Level - Charge immediately.
Gauge needle in Yellow Zone: 10% - 50% Charge Level - Recharge before use.
Gauge needle in Green Zone: 51% - 100% Charge Level - Recharge after use.
Model No. 2032
Sheet 3 of 9
To Next Page
Loading...