Need help?Do you have a question about the Man L16/24 and is the answer not in the manual?
General| Engine Model | L16/24 |
|---|---|
| Cooling System | Water-cooled |
| Fuel Type | Diesel |
| Engine Type | Four-stroke |
| Number of Cylinders | 6 |
Provides technical data and capacities for L27/38 GenSets at different configurations.
Specifies vibration limits and measurement points, including turbocharger vibration.
Details recommended overhaul intervals and expected life times for engine components.
Lists key specifications like cycle, configuration, bore, stroke, and power output.
Details internal fuel oil system components: filters, waste oil, and high-pressure injection.
Specifies requirements and properties for heavy fuel oil (HFO) use in MAN engines.
Lists properties and specifications for Maritime Diesel Oil (MDO).
Defines properties and specifications for Gas Oil / Diesel Oil (MGO).
Provides specifications for biofuels, including transesterified and non-transesterified types.
Details methods for calculating SFOC and applying corrections for various conditions.
Outlines the system, components, oil quantities, and recommendations.
Specifies requirements for SAE 40 lubricating oil used with HFO, including base oil properties.
Lists specifications for SAE 40 lubricating oil suitable for MGO/MDO and biofuels.
Explains how to calculate and evaluate specific lubricating oil consumption (SLOC).
Provides criteria for evaluating lubricating oil condition and determining replacement.
Covers methods for treating and maintaining lubricating oil, including cleaning procedures.
Details requirements for engine coolant, including water type and properties.
Describes cleaning procedures for coolant systems, including agents for deposits.
Explains the internal cooling water system, including low and high temperature circuits.
Outlines quality requirements for compressed air in starting, control, soot blowing, and atomisation.
Details combustion air requirements, intake air to turbocharger, and charge air cooler.
Specifies quality requirements for intake air, including particle size and contamination limits.
Discusses exhaust back-pressure, piping, dimensions, and mounting.
Outlines procedures for starting engines on HFO and MDO, including preheating and prelubrication.
Details various protection functions for alternators and generators.
Provides an overview of the SaCoSone GENSET system, including its components and functions.
Explains the Modbus RTU protocol for GenSet communication, including settings and function codes.
Covers mounting of diesel engines and alternators on rigid base frames using resilient supports.
Outlines the shop test programme, including operating points and load acceptance tests.
Details standard tools for normal maintenance, including cylinder head and piston tools.
To Next Page
