Need help?Do you have a question about the Man L16/24S and is the answer not in the manual?
General| Brand | Man |
|---|---|
| Model | L16/24S |
| Category | Portable Generator |
| Language | English |
Details overhaul recommendations, maintenance intervals, and expected component life times.
Details the components and function of the internal fuel oil system, including filters.
Outlines prerequisites, specifications, and important considerations for using heavy fuel oil.
Details the properties and specifications for Maritime Diesel Oil (MDO).
Provides specifications and properties for gas oil/diesel oil (MGO).
Details the standardized calculation for converting SFOC from reference to site/FAT conditions.
Lists fuel consumption values for various loads and engine types, related to emissions standards.
Describes the construction and function of the fuel injection valve.
Explains the design, operation, and regulation of the fuel injection pump.
Details the components and flow of the internal lubricating oil system.
Outlines specifications and target values for lubricating oil used with HFO.
Provides specifications for lubricating oil used with MGO/MDO and biofuels.
Explains how to calculate and evaluate specific lubricating oil consumption (SLOC).
Details methods for treating and maintaining lubricating oil, including filter and separator use.
Lists criteria and parameters for evaluating and determining lubricating oil replacement.
Outlines requirements and properties for engine coolant, including water and additives.
Explains the design and operation of the internal cooling water system.
Details the design of the two-string central cooling water system with LT and HT circuits.
Outlines quality requirements for compressed air for starting, control, soot blowing, and atomization.
Explains the combustion air system, charge air cooler, and engine room ventilation requirements.
Details the internal exhaust gas system components and pressure considerations.
Covers requirements for external exhaust piping, including back pressure and mounting.
Details SCR technology, components, operation, and certification for NOx reduction.
Provides procedures for starting the engine with HFO and MDO, including preheating and prelubrication.
Details various protection functions for alternators and generators in power management systems.
Lists operational data and alarm/shutdown set points for various engine systems.
Details the system description, including safety system, alarms, and speed control.
Describes the data bus interface for communication with ship alarm and automation systems using Modbus.
Details the Modbus RTU protocol, including settings and function codes for data acquisition.
Explains the Modbus ASCII protocol, its frame format, and accepted commands.
Refers to the Modbus list document for ASCII and RTU communication protocols.
Provides a detailed list of Modbus registers, their addresses, descriptions, units, and signal ranges.
Outlines the shop test program for power plants, including operating points and load acceptance.
To Next Page
