Manaras Opera KEYLESS 042 User Manual

KEYLESS 042
KEYLESS 042
Programming and Installation Instructions
Programming and Installation Instructions
WARNING
TO REDUCE THE RISK OF SEVERE INJURY OR
DEATH TO PERSONS:
1. READ AND FOLLOW ALL INSTALLATION INSTRUCTIONS.
2. Locate the Keypad: (a) within sight of the door, (b) at a minimum height of 5 feet
(1.5 m) above floors, landings, steps or any other adjacent walking surface so small
children are not able to reach it, and (c) away from all moving parts of the door.
3. Activate the door ONLY when it can be seen clearly, is properly adjusted, and there
are no obstructions to the door travel.
Components:
Preparation:
1. Locate the LEARN button on the operator's On-Board Radio Receiver, refer to Figure 1 or the operator's
Installation & Instruction Manual.
2. Ensure that the Rotary Selection Switch on the operator's Electronic Control Board (ECB) is set to B2 (1),
T (4) or TS (5).
Figure 1 - Electronic Control Board (ECB)
3. Undo the screw from the bottom of the case and remove the back cover from the Keypad to install the AAA
battery, refer to Figure 2.
4. Program the Keypad prior to mounting.
1-800-361-2260
www.manaras.com 1 TN1025 REV 4 - 2016/04/11
1,5V AAA BATTERY
2 PCS M3,5 X 20 SCREWS
AND ANCHORS
KEYPAD (TRANSMITTER)
LEARN
BUTTON
LED (WHITE)
ROTARY
SELECTION
SWITCH
ON-BOARD
RADIO
RECEIVER
BOTTOM
SCREW
INSERT
BATTERY
Figure 2 - KEYLESS042 Battery Installation

Manaras Opera KEYLESS 042 Specifications

General

Brand	Manaras Opera
Model	KEYLESS 042
Category	Keypad
Language	English

Summary

Safety and Initial Setup

Safety Warnings

Critical safety instructions to reduce risk of injury or death during operation.

Keypad Components and Preparation

Identification of keypad parts, battery installation, and pre-programming steps.

New Installation and PIN Programming

Program Initial PIN

Steps to set a new personal identification number for the keypad.

Security and Timeout Features

Details on anti-theft auto-lock and timeout error codes during programming.

Single Door Mode Programming

Setting and Pairing

Configure for single door operation and pair with the radio receiver.

Testing Single Door Operation

Verify successful programming and door activation.

Multiple Door Mode Programming

Setting and Pairing

Program the keypad to operate up to four doors sequentially.

Testing Multiple Door Operation

Confirm correct operation for each programmed door.

Mounting Instructions

Keypad Mounting Procedure

Guide on selecting location and physically attaching the keypad unit.

Troubleshooting and Memory Management

Change Existing PIN

Procedure to modify the current personal identification number.

Reset to Factory Defaults

Restore keypad to initial settings if PIN is lost or forgotten.

Delete Receiver Memory

Clear all paired transmitters from the on-board radio receiver.