M&S Systems dmc3-4/dmc1CD - Audio Settings

dmc3-4
M&S Systems | 2861 Congressman Lane | Dallas, Texas 75220 | 800.877.6631 | www.mssystems.com 7
To set the Scan Mode:
1. To change the scan mode, simultaneously press and release PRESET and SOURCE
again. The display shows either Scan1 or Scan2.
Note: Exit out of scan mode by pressing PRESET and SOURCE or waiting for the display
to show the clock time again.
Figure 5—Scan Mode
Audio Settings
Volume
• Music—Adjusts the volume for system music
• Master Station—Adjusts the volume for the speaker on the Master Station only
• Intercom—Adjusts the volume for the system intercom
Tone
• Loudness
• Treble
• Bass
• Balance (if you have the optional stereo power amplifier)
¿
TUNE
SCAn1
A
UTO
TIME
PRESET
POWER
TONE
SOURCE
¿
VOLUME
À
LISTEN TALK
DOOR TALK
¿
TUNE
À
PRESET + SOURCE
Change Scan mode.