MangoKit MD3 - FM Scan and Audio Settings; Bluetooth Connectivity

8.4 Language
The default language is English. To change, select Menu > System
settings > Language >then select your language.
8.5 Factory reset
A factory reset clears all user defined settings, replacing them
with the original default values, so time/ date,preferences/
settings and DAB station list are all lost.
If you select Factory reset, you are asked to confirm by
selecting “Yes” .
9 Troubleshooting and error messages
9.1 Error messages
Message
Description
DAB mode
Service not available
No DAB reception
Signal error
The DAB signal has been interrupted.
No DAB Station
The current station does not broadcast an identity name.
(No Name)
The listed station cannot be found.
No stations found
No DAB stations are available - check aerial.
FM mode
No RadioText No RDS text information is available on this station.
No PTY No RDS programme type information is available.
No Name No RDS station name is being broadcast
General messages
Update failed Software upgrade failed
9.2 Troubleshooting
Check/move antenna, Move radio
Rescan high-strength stations only.
For DAB or DAB+, check the
current status of local coverage
with your national digital radio
authority.
As above then rescan stations
Solutions
Low signal
Low signal
Cause
strength
strength
FM: Hiss
DAB: burbling/
intermittent
cut-out
DAB:
No stations
available’
message
Problem
Message
Description
Time is not set
No time value is currently set on this platform.
Time Not saved Any changes made to the time settings will be lost.
Alarm Not saved Any changes made to the Alarm settings will be lost.
Invalid Date The entered value does not match a valid date.
1615