2-25
14- 3-POSITION KEY-OPERATED IGNITION SWITCH (PLATFORM/OFF/GROUND)
- Set the key switch to the Platform Control position (14-a) to switch on the platform controls.
- Set the key switch to the Stop position to switch off the machine (14-b).
- Set the key switch to the Ground Control position to switch on the ground controls (14-c).
- NB: Ensure that the red Emergency Stop knobs on the ground control and platform control
panels are pulled to the ON position.
- Remarks: In cold weather (below 10°C), hold down the pre-heating button for 5 or 10 seconds
before starting the engine. Do not use the pre-heating button for more than 20 seconds at
one time.
- If the engine does not start after 15 seconds, determine the cause of the problem and rectify it.
Wait 60 seconds before trying to start the engine again.
- In cold weather (-6°C and below), preheat the engine for 5 minutes before using it to avoid
damaging the hydraulic system.
- In extremely cold weather (below -18°C), the machines must be fitted with optional cold
weather starting kits. Starting the engine when the temperature is below -18°C may require
the use of an auxiliary battery.
15- RED EMERGENCY STOP KNOB
- Push in the red Emergency Stop knob to the OFF position to stop all the machine’s functions.
Pull the red Emergency Stop knob out to the ON position to use the machine.
- Repair any function that is active when one of the Emergency Stop knobs is pressed.
15
14
14-a
14-b
14-c
647367 (01/03/2017)
100/120 SC-2 / 140 SC
To Next Page
Loading...
Need help?
General
