EasyManua.ls Logo

Manitou 160 ATJ PLUS Euro 3 - SERVICING SCHEDULE 160 ATJ PLUS EURO 3

Manitou 160 ATJ PLUS Euro 3
146 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1-8
D
RIVING
INSTRUCTIONS
A - BEFORE STARTING THE PLATFORM
- Ensure that the intermediate rail is fully in the locked position before operating the platform from the basket.
- If the platform is new, see the paragraph : before starting the platform for the first time in Chapter : 1 - safety advice and
instructions.
- Carry out daily maintenance (see chapter 3 - MAINTENANCE, A - DAILY pages).
- Before starting the platform, check the levels
IC PLATFORMS :
ELECTRIC PLATFORMS :
IC engine oil Hydraulic reservoir oil
Hydraulic reservoir oil Battery charge level
Fuel
Coolant
- The lifting platform must be in transport position (with the arms completely folded back or the scissors in the low position) before
you enter it.
- Make sure the horn works.
- Check before you use the lifting platform that the access door is properly locked.
B - DRIVERS OPERATING INSTRUCTIONS
- Whatever his experience, the operator is advised to familiarize himself with the position and operation of all the controls and
instruments before operating the platform.
- Wear suitable clothing for driving the platform, do not wear baggy clothes.
- Make sure you have the appropriate protective equipment for the job to be done.
- Prolonged exposure to high noise levels may cause hearing problems. It is recommended to wear ear muffs to protect against
excessive noise.
- Always pay attention when using the platform. Do not listen to the radio or music using headphones or earphones
- For increased comfort, adopt the correct position in the driver’s cab.
- The operator must always be in his normal position in the driver’s seat : extending arms or legs (or, in general, any part of the
body), outside the basket is forbidden.
- Safety helmets must be worn.
- MANITOU recommends a safety harness in the operator’s size be provided when the platform is in use (for the harness
attachement in the basket , see chapter 2 - DESCRIPTION, CHECKING AND CONTROL INSTRUMENTS pages).
- The control units must never in any event be used for any other than their intended purposes (e.g. climbing onto or down from
the platform, coat-rack, etc.).
- In the case of scissors-type platforms, it is forbidden to use the platform without the guardrails in place.
- Suspending a load under the basket or on any part of the lifting apparatus is strictly forbidden.
- The operator must not climb into or get down from the basket unless it is at ground level (with the lifting system folded).
- The platform must not be fitted with any accessory increasing the machine’s wind profile.
- Do not use a ladder or any improvised constructions in the basket to reach greater heights.
- Do not climb on the sides of the basket to reach greater heights.
- Never use the lifting platform with wet or greasy hands and shoes.
C - ENVIRONMENT
- Comply with site safety regulations.
- The platform can be manoeuvred from the ground: ensure that you forbid access.
- If you have to use the platform in a dark area or at night, make sure it is equipped with working lights.
- The platforms may not be used as cranes or elevators for the permanent transport of people or materials, nor as jacks or
supports.
- When operating, ensure that there is no one or anything impeding the platform’s progress ans operation.
- When raising the platform, ensure that no one or anything inpedes the platform’s operation and do not perform any inappropriate
manœuvres.
547408 EN (15/05/2012)

Table of Contents

Other manuals for Manitou 160 ATJ PLUS Euro 3

Related product manuals