Manitou MLT625-75 H S1-E3 - Page 102

3-13-166
11
11
22
33
44
1010
77
55
99
88
1010
66
7 - Lubricator of the compensation cylinder foot axle (1 lubricator).7 - Lubricator of the compensation cylinder foot axle (1 lubricator).
8 8 - - Lubricator Lubricator of of the the compensation compensation cylinder cylinder head head axle axle (1(1
lubricator).lubricator).
FRONT AND REAR WHEELS REDUCER PIVOTSFRONT AND REAR WHEELS REDUCER PIVOTS
9 9 - - Lubricators Lubricators of of the the wheel wheel reduction reduction gear gear pivots pivots (8(8
lubricators).lubricators).
REAR AXLE REAR AXLE OSCILLAOSCILLATIONTION
10 - Rear 10 - Rear axle oscillation lubricators (2 lubricators).axle oscillation lubricators (2 lubricators).

B5/2
B5/2
B5/1B5/1
11
B5 - HYDRAULIC OIL LEVELB5 - HYDRAULIC OIL LEVEL
CHECKCHECK
If necessary, remove and reconnect the hydraulic attachment (see: 4 - OPTIONALIf necessary, remove and reconnect the hydraulic attachment (see: 4 - OPTIONAL
ATTACHMENTS FOR USE WITH THE RANGE: PICKING UP THE ATTACHMENTS). Place theATTACHMENTS FOR USE WITH THE RANGE: PICKING UP THE ATTACHMENTS). Place the
lift truck on level ground with the engine stopped and the jib retracted and lowered to itslift truck on level ground with the engine stopped and the jib retracted and lowered to its
maximum extent.maximum extent.
-- Refer to gaRefer to gauge 1 (fig. Buge 1 (fig. B5/1).5/1).
-- The oil level is The oil level is correct when it is at the lecorrect when it is at the level of the red point.vel of the red point.
-- If necessary, add oil (see: 3 - MAINTENAIf necessary, add oil (see: 3 - MAINTENANCE: LUBRICANTS ANCE: LUBRICANTS AND FUEL).ND FUEL).
-- RemoRemove cap 2 (fig. Bve cap 2 (fig. B5/2).5/2).
-- Add oil tAdd oil through filler port 3 (fig. hrough filler port 3 (fig. B5/2).B5/2).
Use a clean funnel and clean the underside of the Use a clean funnel and clean the underside of the oil drum before filling.oil drum before filling.
-- ReplaReplace thce the cape cap..
https://www.forkliftpdfmanuals.com/