Manitou MLT625-75 H S1-E3 - Page 103

3-13-177
B7B7
33
B6/2B6/2
55
33
44
22
11
33
22
B6/1B6/1
22
11
11
pp pp
-- Check visually thaCheck visually that there is no leakage in t there is no leakage in the tank and pipes.the tank and pipes.
Always maintain the oil level at maximum as cooling depends on the oil flowing throughAlways maintain the oil level at maximum as cooling depends on the oil flowing through
the tank.the tank.
B6 - BRAKE OIL LEVELB6 - BRAKE OIL LEVEL
CHECKCHECK
Place the lift truck on level ground.Place the lift truck on level ground.
-- Loosen the two knurled screws 1 (Loosen the two knurled screws 1 (fig. B6/1) and remove thfig. B6/1) and remove the protective cover 2e protective cover 2
(fig. B6/1).(fig. B6/1).
-- Check tank 3 (fig. B6/2). The correct level must stand at the MACheck tank 3 (fig. B6/2). The correct level must stand at the MAX level in the tank.X level in the tank.
-- If necessary, add oil (see: 3 - MAINTENAIf necessary, add oil (see: 3 - MAINTENANCE: LUBRICANTS ANCE: LUBRICANTS AND FUEL).ND FUEL).
-- RemoRemove cap 4 (fig. Bve cap 4 (fig. B6/2).6/2).
-- Add oil tAdd oil through filler port 5 (fig. hrough filler port 5 (fig. B6/2).B6/2).
-- ReplaReplace thce the cape cap..
-- Check visually thaCheck visually that there is no leakage in t there is no leakage in the tank and pipes.the tank and pipes.
If the braking oil level is abnormally low, consult your dealer.If the braking oil level is abnormally low, consult your dealer.
B7 - WINDSCREEN WASHER LIQUID LEVELB7 - WINDSCREEN WASHER LIQUID LEVEL
CHECKCHECK
- Open the I.C. engine bonnet.- Open the I.C. engine bonnet.
-- RemoRemove cap 1 (five cap 1 (fig. B7).g. B7).
-- Visually check thVisually check the level in tank 2 (e level in tank 2 (fig. B7).fig. B7).
-- If necessary add windscreen washer liquid (see: If necessary add windscreen washer liquid (see: 3 - MAINTENANCE: 3 - MAINTENANCE: LUBRICANTSLUBRICANTS
AND FUEL) through filler port 3 (fig. B7).AND FUEL) through filler port 3 (fig. B7).
-- ReplaReplace thce the cape cap..

B8 - CAB VENTILATION FILTER
B8 - CAB VENTILATION FILTER
CLEANCLEAN
- Lift out cabin ventilation filter 1 (fig. B8).- Lift out cabin ventilation filter 1 (fig. B8).
- Clean the filter with a compressed air jet.- Clean the filter with a compressed air jet.
-- Check its condition and change if necessary (see: 3 - MAINTENANCE: FILCheck its condition and change if necessary (see: 3 - MAINTENANCE: FILTERS CARTRIDGESTERS CARTRIDGES
AND BELTS).AND BELTS).
- Put the filter back into place.- Put the filter back into place.
B8B8
11
https://www.forkliftpdfmanuals.com/