3-23-255
- Place a container under drain plug 1 (fig. E1/1) and unscrew the - Place a container under drain plug 1 (fig. E1/1) and unscrew the plug.plug.
- Open access panel 2 (fig. E1/2).- Open access panel 2 (fig. E1/2).
- Remove filler plug 3 (fig. E1/2) in order to ensure that the - Remove filler plug 3 (fig. E1/2) in order to ensure that the oil is drained properly.oil is drained properly.
- Rinse out with ten litres of clean diesel through filler por- Rinse out with ten litres of clean diesel through filler port 4 (fig. E1/2).t 4 (fig. E1/2).
- Refit and tight- Refit and tighten the drain plug (tien the drain plug (tightening torque 29 to 39ghtening torque 29 to 39 N.m)N.m)21-29 lbf/ft21-29 lbf/ft..
- Fill the fuel tank with clean diesel filtered through the filler por- Fill the fuel tank with clean diesel filtered through the filler port.t.
- Refit the filler plug.- Refit the filler plug.
- Close the access panel.- Close the access panel.
-- If necessary, bleed the fuel circuit (see: 3 - MAIIf necessary, bleed the fuel circuit (see: 3 - MAINTENANCE: G1 - FUEL SYSTENTENANCE: G1 - FUEL SYSTEM).M).
E2 - SAFETY DRY E2 - SAFETY DRY AIR FILAIR FILTER CARTRIDGETER CARTRIDGE
CHANGECHANGE
-- For the disassembly and reassFor the disassembly and reassembly of the dry air filter carembly of the dry air filter cartridge, see: 3 - MAINTEtridge, see: 3 - MAINTENANCE:NANCE:
D3 - AIR FILTER CARTRIDGE.D3 - AIR FILTER CARTRIDGE.
-- Gently remove the dry air filter safety Gently remove the dry air filter safety cartridge 1 (fig. E2), taking care to avocartridge 1 (fig. E2), taking care to avoid spillingid spilling
the dust.the dust.
- Clean the gasket sur- Clean the gasket surface on the filter with a damp, clean lint-free cloth.face on the filter with a damp, clean lint-free cloth.
-- Check the condition of Check the condition of the new safety cartridge before fitting (see: 3 - Mthe new safety cartridge before fitting (see: 3 - MAINTENANCE:AINTENANCE:
FILTERS AND BELTS).FILTERS AND BELTS).
-- Insert the carInsert the car tridge within the axis of tridge within the axis of the filter and push it the filter and push it home, pressing against thehome, pressing against the
outer edge and not the centre.outer edge and not the centre.
NOTE:NOTE: The safety cartridge changing frequency is given for information onlyThe safety cartridge changing frequency is given for information only. It must be. It must be
changed for every two changes of the dry air filter cartridge.changed for every two changes of the dry air filter cartridge.
E2E2
11
E1/2E1/2
44
22
33
E3 - HYDRAULIC OIL
E3 - HYDRAULIC OIL
DRAINDRAIN
E4 - BRAKE ACCUMULATOR UNIT FILTERE4 - BRAKE ACCUMULATOR UNIT FILTER
CHANGECHANGE
Stop the I.C. engine on level ground, with the Stop the I.C. engine on level ground, with the jib raised and remove the pressure from jib raised and remove the pressure from thethe
circuits by acting on the hydraulic controls.circuits by acting on the hydraulic controls.
Before carrying out Before carrying out any work, thoroughly clean any work, thoroughly clean the areas concerned by these the areas concerned by these maintenance operationsmaintenance operations..
DRAINING THE OILDRAINING THE OIL
-- Place a container Place a container under drain plugs 1 (under drain plugs 1 (fig. E3/1) and ufig. E3/1) and unscrew them.nscrew them.
-- Remove filler plug 2 (fiRemove filler plug 2 (fig. E3/2) in order to ensure that the oil is drained properlyg. E3/2) in order to ensure that the oil is drained properly..
Dispose of the drain Dispose of the drain oil in oil in an ecological manner.an ecological manner.
E3/1E3/1
11
11
E3/2E3/2
To Next Page
Loading...
