Manitou MLT625-75 H S1-E3 - Page 112

3-23-266
REPLACING THE BRAKE REPLACING THE BRAKE ACCUMULAACCUMULATOR UNIT TOR UNIT FILFILTERTER
-- Unscrew plug 3 (fig. E3/3), lift out the filter and fit a new one (see: 3 - MAINTENANCE:Unscrew plug 3 (fig. E3/3), lift out the filter and fit a new one (see: 3 - MAINTENANCE:
FILTERS CARTRIDGES AND BELTS).FILTERS CARTRIDGES AND BELTS).
-- Refit and Refit and tighten plug 3 tighten plug 3 (fig. E3/3(fig. E3/3) (tightening ) (tightening torque 70 to 80torque 70 to 80 N.m)N.m)52 - 59 lbf/ft52 - 59 lbf/ft..
FILLING UP THE OILFILLING UP THE OIL
-- Refit and tRefit and tighten draighten drain plugs 1 (fin plugs 1 (fig. E3/1) (ig. E3/1) (tightenitightening torque 29 to 39ng torque 29 to 39 N.m)N.m)
21-29 lbf/ft21-29 lbf/ft
..
-- Fill up with oil (sFill up with oil (see: 3 - MAINTENANCE: ee: 3 - MAINTENANCE: LUBRICANTS AND FUELUBRICANTS AND FUEL) through filler port 4 (fig.L) through filler port 4 (fig.
E3/2).E3/2).
Use a clean container and funnel and clean the underside of the oil Use a clean container and funnel and clean the underside of the oil drum before filling.drum before filling.
--
Observe the oil level on dipstick 5 (fig. E3/4), the oil level should be at the level of the redObserve the oil level on dipstick 5 (fig. E3/4), the oil level should be at the level of the red
point.point.
- Check for any possible leaks at the drain plugs.- Check for any possible leaks at the drain plugs.
- Refit filler plug 2 - Refit filler plug 2 (fig. E3/2).(fig. E3/2).
E3/3E3/3
33
44
22
E3/4E3/4
55

E5 - SEAT BELT
E5 - SEAT BELT
CHECKCHECK
SEAT BELT WITH TWO ANCHORING POINTSSEAT BELT WITH TWO ANCHORING POINTS
- Check the following points:- Check the following points:
• Fixing of the anchoring points on the seat.• Fixing of the anchoring points on the seat.
• Cleanness of the strap • Cleanness of the strap and the locking mechanism.and the locking mechanism.
• Triggering of the locking mechanism.• Triggering of the locking mechanism.
• Condition of the strap • Condition of the strap (cuts, curled edges).(cuts, curled edges).
REELED SEAT BELT WITH TWO ANCHORING POINTSREELED SEAT BELT WITH TWO ANCHORING POINTS
- Check the points listed above together with the following points:- Check the points listed above together with the following points:
• The correct winding of the belt.• The correct winding of the belt.
• Condition of the reel guards.• Condition of the reel guards.
• Roller locking mechanism when the strap is given a sharp tug.• Roller locking mechanism when the strap is given a sharp tug.
https://www.forkliftpdfmanuals.com/