1-161-16
overloaded, replace the load in the place from which it was taken.overloaded, replace the load in the place from which it was taken.
-- If possible lower the load withIf possible lower the load without shifting the lift truck. Lift the jib (1) to releasout shifting the lift truck. Lift the jib (1) to release the load,e the load,
retract (2) and lower the jib (3) to retract (2) and lower the jib (3) to bring the load into the transporbring the load into the transport position (fig. F4).t position (fig. F4).
-- If this is If this is not possible, back up not possible, back up the lift truck (1), manoeuvring very gently and carefully tothe lift truck (1), manoeuvring very gently and carefully to
release the load. Retract (2) and lower the jib (3) to bring the load into the transporrelease the load. Retract (2) and lower the jib (3) to bring the load into the transport positiont position
(fig. F5).(fig. F5).
22
11
22
F3F3
11
33
22
F4F4
11
22
33
F5F5
LAYING A HIGH LOAD ON TYRES
LAYING A HIGH LOAD ON TYRES
- Approach the load in the transpor- Approach the load in the transport position in front of the pile (fig. F6).t position in front of the pile (fig. F6).
- Put the handbrake on and set the forward/reverse selector to neutral.- Put the handbrake on and set the forward/reverse selector to neutral.
-- Lift and extend the jib (1) (2) until the load is above the piLift and extend the jib (1) (2) until the load is above the pile, while keeping an eye on thele, while keeping an eye on the
longitudinal stability limiter and warning device (see: INSTRUCTIONS FOR HANDLING Alongitudinal stability limiter and warning device (see: INSTRUCTIONS FOR HANDLING A
LOAD: C - LOAD: C - LONGITUDINAL STABILITY LIMITER AND WARNING DEVICE). If necessary, moveLONGITUDINAL STABILITY LIMITER AND WARNING DEVICE). If necessary, move
the lift truck (3) forward (fig. F7), driving very slowly and carefully.the lift truck (3) forward (fig. F7), driving very slowly and carefully.
-- Place the load in a horizontal position and lay it down on the pile by lowering and retractingPlace the load in a horizontal position and lay it down on the pile by lowering and retracting
the jib (1) (2) in order to the jib (1) (2) in order to position the load correctly (fig. F8).position the load correctly (fig. F8).
-- If possible, release the fork by alternately retracting and raising the jib If possible, release the fork by alternately retracting and raising the jib (1) (fig. F9). Then set(1) (fig. F9). Then set
the forks into transport position.the forks into transport position.
-- If this is not If this is not possible, reverse thpossible, reverse the lift truck (1) very slowly and carefully to e lift truck (1) very slowly and carefully to release therelease the
forks (fig. F10). Then set them into transporforks (fig. F10). Then set them into transport position.t position.
F6F6
F7F7
To Next Page
Loading...
