1-191-19
LAYING A HIGH LOAD ON STABILIZERSLAYING A HIGH LOAD ON STABILIZERS
-- Raise and extend the jib (1) (2) until the load is above the elevation (fig. G9), whileRaise and extend the jib (1) (2) until the load is above the elevation (fig. G9), while
monitoring the longitudinal stability limiter and warning device (see: INSTRUCTIONS FORmonitoring the longitudinal stability limiter and warning device (see: INSTRUCTIONS FOR
HANDLING A LOAD: C HANDLING A LOAD: C - LONGITUDINAL STABILITY LIMITER AND WARNING DEVICE- LONGITUDINAL STABILITY LIMITER AND WARNING DEVICE).).
-- Position the load horizontaPosition the load horizontally and release it by lowering and retracting the jib (1) (lly and release it by lowering and retracting the jib (1) (2) to2) to
position the load correctly (fig. G10).position the load correctly (fig. G10).
- Release the forks by alternating retracting and raising the jib (3) - Release the forks by alternating retracting and raising the jib (3) (fig. G11).(fig. G11).
- If possible, set the jib in transpor- If possible, set the jib in transport position without moving the lift truck.t position without moving the lift truck.
11
22
33
G8G8
11
22
G7G7
11
22
G9G9
33
G11G11
11
22
G10G10
H - TAKING UP AND LAYING DOWN A SUSPENDED
H - TAKING UP AND LAYING DOWN A SUSPENDED LOADLOAD
WARNING: Failure to follow the above instructions may lead the lift WARNING: Failure to follow the above instructions may lead the lift truck to loose stability and overtruck to loose stability and over turn.turn.
MUST be used with a lift MUST be used with a lift truck equipped with an operational hydraulic movement cut-out device.truck equipped with an operational hydraulic movement cut-out device.
CONDITIONS OF USECONDITIONS OF USE
- The length of the sling or the - The length of the sling or the chain shall be as shorchain shall be as short as possible to limit swinging of the load.t as possible to limit swinging of the load.
- Lift the load ver- Lift the load ver tically along its axis, never by pulling sideways or lengthways.tically along its axis, never by pulling sideways or lengthways.
HANDLING WITHOUT MOVING THE LIFT TRUCKHANDLING WITHOUT MOVING THE LIFT TRUCK
-- Whether on stabilisers or on tyres, the lateraWhether on stabilisers or on tyres, the lateral attitude must not exceed 1 % and the longitudinal attitudl attitude must not exceed 1 % and the longitudinal attitude must not exceed 5%, thee must not exceed 5%, the
bubble of the level must be held at “0”.bubble of the level must be held at “0”.
- Ensure that the wind speed is not - Ensure that the wind speed is not higher than 10 m/s.higher than 10 m/s.
- Ensure that there is no - Ensure that there is no one between the load and the lift trone between the load and the lift truck.uck.
I - TRAVELLING WITH A SUSPENDED LOI - TRAVELLING WITH A SUSPENDED LOADAD
-- Before moving, inspect the terrain in order to avoid excessive slBefore moving, inspect the terrain in order to avoid excessive slopes and cross-falls, bumps and potopes and cross-falls, bumps and potholes, or soft ground.holes, or soft ground.
To Next Page
Loading...
