THIS CHART IS ONLY A GUIDE AND SHOULD NOT BE USED TO OPERATE THE CRANE.
The individual crane’s load chart, operating instructions and other instructional plates must be read and understood prior to operating the crane.
20
Load chart
Pounds
160 ft
40,000 lb36 ft - 59 ft
100%
27 ft 10 in
spread
360
°
Feet
36 ft LENGTH 59 ft LENGTH
5
°
OFFSET
20
°
OFFSET
40
°
OFFSET
5
°
OFFSET
20
°
OFFSET
40
°
OFFSET
#0091 #0092
NOTES:
1. All capacities above the bold line are based on
structural strength of boom extension and do not
exceed 85% of tipping loads, in accordance with
SAE J765.
2. 36 ft boom extension may be used for single or
double line lifting service. 59 ft boom extension
may be used for single line lifting service only.
WARNING: Lifting with the 36 ft extension base,
with the 23 ft extension fly either erected or folded
along side of extension base, is strictly prohibited.
3. Radii listed are for a 160 ft boom with the boom
extension erected. For main boom lengths less
than 160 ft, the rated loads are determined
by boom angle. Use only the column which
corresponds to the boom extension length and
offset for which the machine is configured. For
boom angles not shown, use the rating of the next
lower boom angle.
WARNING: Operation of this machine with
heavier loads than the capacities listed is strictly
prohibited. Machine tipping with boom extension
occurs rapidly and without advance warning.
4. Boom angle is the angle above or below horizontal
of the longitudinal axis of the boom base section
after lifting rated load.
5. Capacities listed are with outriggers properly
extended and vertical jacks set only.
ft ft luffing folding boom extension fixed angle ft main boom
To Next Page
Loading...
