THIS CHART IS ONLY A GUIDE AND SHOULD NOT BE USED TO OPERATE THE CRANE.
The individual crane’s load chart, operating instructions and other instructional plates must be read and understood prior to operating the crane
21Grove RT9130E
Load chart
Pounds
160 ft
40,000 lb59 ft
100%
27 ft 10 in
spread
360°
Feet
59 ft LENGTH WITH 26 ft INSERT 59 ft LENGTH WITH 52 ft INSERT
5°
OFFSET
20
°
OFFSET
40
°
OFFSET
5
°
OFFSET
20
°
OFFSET
40
°
OFFSET
#0095 #1095
26 ft - 52 ft
insert
NOTES:
1. All capacities above the bold line are based on
structural strength of boom extension and do
not exceed 85% of tipping loads, in accordance
with SAE J-765.
2. 59 ft folding boom extension length may be
used for single line lifting service only.
NOTE: Lifting with the 36 ft extension base with
either one or two 26 ft insert sections installed is
not permitted.
3. For main boom lengths less than 160 ft with
the boom extension erected, the rated loads
are determined by boom angle. Use only
the column which corresponds to the boom
extension length and offset for which the
machine is set up. For boom angles not shown,
use the rating of the next lower boom angle.
4. WARNING: Operation of this machine with
heavier loads than the capacities listed is
strictly prohibited. Machine tipping with boom
extension occurs rapidly and without advance
warning.
5. Boom angle is the angle above or below
horizontal of the longitudinal axis of the boom
base section after lifting rated load.
6. Capacities listed are with outriggers properly
extended and vertical jacks set only.
ft luffing folding boom extension with or inserts fixed angle ft main boom
To Next Page
Loading...
