Manitowoc Grove RT9130E-2

Other manuals for Manitowoc Grove RT9130E-2

Questions and Answers

K
Kim DouglasAug 6, 2025
Why is there pump noise and hydraulic oil foaming in the reservoir of my Manitowoc Construction Equipment?
- J
  Judy ThompsonAug 6, 2025
  If you observe pump noise accompanied by hydraulic oil foaming in the reservoir of your Manitowoc Construction Equipment, there are several potential causes. First, check the hydraulic oil level and replenish if low, inspecting the system for leaks and repairing them as needed. Also, ensure the engine speed is not excessive and regulate it if necessary. Finally, inspect all suction lines for security and proper repair, tightening, repairing, or replacing parts as needed to prevent air from entering.
M
Mr. Shawn PerryAug 13, 2025
How to troubleshoot no hydraulic oil flow in Manitowoc Grove RT9130E-2 systems?
- M
  morganaaronAug 13, 2025
  If your Manitowoc Construction Equipment's hydraulic systems aren't flowing oil, begin by checking the hydraulic oil level and looking for leaks, making any necessary repairs and refilling the reservoir. Inspect the reservoir-to-pump suction lines for damage or restrictions, ensuring they're secure, free of cracks, and properly attached; tighten, repair, or replace parts as needed. If the drive shaft is damaged or sheared, remove and repair or replace it. Internal contamination can also be a factor, so drain the system, flush it with the recommended oil mixture, and then refill it with the recommended hydraulic oil.
A
Alexis BatesAug 22, 2025
What to do if my Manitowoc Construction Equipment has a slow response?
- M
  Michael AdamsAug 22, 2025
  If you're experiencing slow response in your Manitowoc Construction Equipment, start by checking the hydraulic oil level, looking for leaks, and refilling the reservoir as needed. Also, consider the hydraulic oil temperature: if it's too low, warm up the system; if it's too high, troubleshoot the cooler circuit, paying attention to the in-line check valve and related hydraulic circuits. Lastly, faulty pump sections can cause slow response, so repair or replace the pump sections or the entire pump if necessary.
C
Corey SchneiderAug 29, 2025
How to reduce excessive pressure buildup in Manitowoc Construction Equipment?
- M
  michael00Aug 29, 2025
  If you're encountering excessive pressure buildup in your Manitowoc Construction Equipment, first check the system relief valve setting using an adequate pressure gauge and adjust it as necessary. Also, inspect the pump-to-control valve supply line for any restrictions, cleaning, repairing, or replacing the line as needed.

Manitowoc Grove RT9130E-2 Specifications

General

Category	Rough Terrain Crane
Manufacturer	Manitowoc
Model	Grove RT9130E-2
Drive	4x4
Maximum Lift Capacity	130 USt (118 mt)
Main Boom Length	12.9 m to 48.8 m
Maximum Boom Length	48.8 m
Engine Model	Cummins QSB6.7
Steering Modes	2-wheel, 4-wheel, crab
Carrier Overall Height	3.81 m