Manitowoc Grove RT9130E-2 - Cab Overhead Controls; Skylight Window Latch; Skylight Wiper and Wiper Motor; Skylight Sunscreen

OPERATING CONTROLS AND PROCEDURES RT9130E-2 OPERATOR MANUAL
3-8 Published 3-1-2018, Control # 559-03
select 1 through 6 for forward or 1 through 3 for reverse
gears.
The transmission has six forward gears and three reverse
gears. To use the three low gears, put the Drive Axle switch
at four-wheel drive. To use the three high gears, put the Drive
Axle switch at two-wheel drive.
CAB OVERHEAD CONTROLS
.
Skylight Window Latch
The skylight window latch (1, Figure 3-3) is at the front of the
window. Squeeze the latch and slide the window to the rear
to open. To close, slide the window forward until the latch
engages.
Skylight Wiper and Wiper Motor
The skylight wiper (2, Figure 3-3) is controlled by the wiper
switch (4, Figure 3-4) and operated by the wiper motor (2,
Figure 3-3).
Skylight Sunscreen
The Skylight Sunscreen (3, Figure 3-3) is used to diminish
direct sunlight. The sunscreen is self retracting and can be
set to screen all the light or adjusted rearward by moving it
into the notches provided.
Overhead Light
The cab Overhead Light (4, Figure 3-3) is on the right rear
corner of the cab overhead console and provides illumination
in the cab. The Overhead Light is controlled by a switch on
the light.
Cab Circulating Fan
The Cab Circulating Fan (5, Figure 3-3) is located on the left
front side of the cab, above the window frame. A swivel
allows the fan to be rotated and a switch on the fan base
controls the fan. The switch has a High, Low and Off position.
Right Side Window Latch
The window on the right side of the cab can be opened.
Squeeze latch (6) to release the window and slide forward.
To close slide the window rearward until the latch engages.
Item Description
1 Skylight Window Latch
2 Skylight Wiper & Motor
3 Skylight Sunscreen
4 Overhead Light
5 Cab Circulating Fan
6 Window Latch
7 Overhead Control Panel
FIGURE 3-3
1
2
3
5
4
7
6