OPERATING CONTROLS AND PROCEDURES RT9130E-2 OPERATOR MANUAL
3-24 Published 3-1-2018, Control # 559-03
Telescope Control Foot Pedal
The Telescope Control Foot Pedal, equipped on cranes with
an auxiliary hoist, (3, Figure 3-13) is located on the left side
of the cab floor. Pushing forward on the top of the pedal will
extend the boom and pushing down on the bottom of the
pedal will retract the boom.
Service Brake Foot Pedal
The Service Brake Foot Pedal (4, Figure 3-13) is the second
pedal from the right on the cab floor. Depressing the pedal
controls the application of the service brakes.
Foot Throttle Pedal
The Foot Throttle Pedal (5, Figure 3-13) is located under the
Rated capacity limiter (RCL) display module, on the floor. It is
used to control engine speed which increases or decreases
proportionately with the amount of foot pressure applied to
the pedal. The pedal is electrically connected to the
superstructure control module which sends the signal to the
engine ECM via the J1939 data link.
To Next Page
Loading...
Need help?
General
