OPERATING CONTROLS AND PROCEDURES RT9130E-2 OPERATOR MANUAL
3-6 Published 3-1-2018, Control # 559-03
Figure 3-2 Item Numbers
Turn Signal Lever and Windshield Wiper/
Washer/Headlight /Horn Controls
The Turn Signal Lever and Windshield Wiper/Washer
Controls (1, Figure 3-2) are located on the left side of the
steering column. Pushing the turn signal lever down causes
the left front and left rear turn signals to flash. Pushing the
turn signal lever up causes the right front and right rear turn
signals to flash.
The windshield wiper switch is incorporated in the turn signal
lever. The knob of the lever has three positions: O, I, and II.
Pushing the button in the end of the knob energizes the
windshield washer pump to spray washer fluid on the
windshield. Positioning the knob to I operates the wiper at
low speed and positioning the knob to II operates the wiper
at high speed. Positioning the knob to O turns the wiper
motor off and automatically returns the wiper to the parked
position.
Pushing the small button on the end of the lever sounds the
horn.
Grasp the center section of the lever, push in and rotate to
dim the headlights.
Steering Column Tilt/Telescope Lever
The steering control column can be rotated forward
approximately 30° and raised approximately 2.5 inches.
Move the control lever (2, Figure 3-2) down to lock the
steering column in place; rotating the lever up releases the
steering column for the desired adjustments.
Park Brake Control Switch
The Park Brake Control Switch (3, Figure 3-2) is located on
the front of the steering column. This two-position rocker
switch (ON/OFF) is used to apply and release the parking
brake on the transmission. The red Park Brake Indicator light
is illuminated when the pressure switch in the brake release
system is activated and the brake is applied. The switch has
a lock to prevent accidental activation.
Headlights Switch
The Headlights Switch (4, Figure 3-2) is located on the front
of the steering column. This three-position rocker switch
(OFF/PARK/HEADLIGHT) controls operation of the
instrument lights, switch LED’s, and the marker lights on the
front, rear, and side of the crane. When the switch is in the
ON position, the LED in the switch is illuminated.
Drive Axle Selector Switch
The Drive Axle Selector Switch (5, Figure 3-2) is located on
the front of the steering column. This two-position rocker
switch is used to select either Two-Wheel Drive (HIGH
range) or Four-Wheel drive (LOW range). The switch
controls a solenoid valve (energized for two-wheel drive) that
operates the speed range and axle disconnect cylinders on
the transmission. When the switch is in the four-wheel drive
position, the Drive Axle Indicator light on the steering column
is illuminated.
Item Description
1
Turn Signal Lever and Windshield Wiper/
Washer/Headlight /Horn Controls
2
Steering Column Tilt/Telescope Lever
3
Park Brake Control Switch
4
Headlights Switch
5
Drive Axle Selector Switch
6
Hazard Lights Switch
7 Engine Diagnostic/Speed Control Switch
8
Increment/Decrement Switch
9
Ignition Switch
10
Transmission Shift Lever
11 Gauge Display
FIGURE 3-2
7649-1
1
2
4
3
8
9
6
5
7
10
11
CAUTION
Avoid Crane Damage!
Do not engage the parking brake while the vehicle is
moving. Damage to the crane can occur.
Disengage the parking brake before driving. Damage to
the crane can occur.
To Next Page
Loading...
