SERVICE 1400H OPERATOR AND SERVICE MANUAL
5-54 Published 10-30-2014 Control # 040-09
OUTRIGGER CALIBRATION
NOTE: All measurements are in inches (mm)
Side Pads
1. With a pair of inside/outside calipers, measure the inside
width of the outer section outrigger (W
i
) at the front pad
location and three feet back from the front of the section
and record the smallest measurement.
Note: Method of calibration is the same for the 1st or
2nd section outrigger.
2. With the inside/outside calipers, measure the outside
width of the appropriate inner section (W
o
) at the rear of
the section and three feet from the rear. Record the
largest measurement.
3. Measure the thickness of the wear pads and record
(t
wp
).
4. Subtract the largest outside width (W
o
) of the inner
section and the thickness of the two pads (t
wp
) from the
inside width of the outer section (W
i
). Add shims as
required [each shim is 0.03 (0,8) or 0.06 (1,6) thick] to
tighten the pads so that there is 0.00 - 0.06 (0,00 - 1,6
clearance between the widest part of the inner outrigger
section and the most narrow part of the outer outrigger
section when shims and pads are installed. See
example.
5. Repeat procedure when installing 1st/2nd outriggers
into outrigger boxes subbase.
OUTSIDE
CALIPERS
INSIDE
CALIPERS
W
o
2 PLCS TOP
INNER SECTION
W
o
1 PLC BOTTOM
To Next Page
Loading...
