Manitowoc National Crane NC1400H - Truck Requirements; Configuration 1 - 14127 H; Configuration 2 - 14127 H

INSTALLATION 1400H OPERATOR AND SERVICE MANUAL
7-4 Published 10-30-2014 Control # 040-09
TRUCK REQUIREMENTS
Configuration 1 - 14127H
This configuration allows full capacity in a 180° working
area over the rear of the truck.
Requires 20,000 lb (9072 kg) GAWRF, 40,000 lb (18 144
kg) GAWRR, 60,000 lb (27 215 kg) GVWR, RSOD rear
stabilizers and sub-base. Full capacity work area is rear 180°
of vehicle from outrigger to outrigger. Truck frame must have
or be capable of being reinforced to 30.0 in
3
S.M. (492 cm
3
)
and 3,300,000 lb-in (372 850 Nm) RBM under the crane,
spring hanger to spring hanger.
*Bare chassis weight.
Configuration 2 - 14127H
This mount requires front stabilizer for full capacity 360°
around the truck. Front stabilizer gives the machine a solid
base helping the operator control loads.
Requires 20,000 lb (9072 kg) GAWRF, 40,000 lb (18 144
kg) GAWRR, 60,000 lb (27 215 kg) GVWR, sub-base, SFO
and RSOD rear stabilizers. Truck must have 30.0 in
3
(492 cm
3
)
section modulus and 3,300,000 lb-in (372 850 Nm) RBM or be
capable of being reinforced to this strength under the crane
frame through to the front suspension. Normally a tapered
frame cannot be reinforced to this requirement. Additional
truck frame requirements must be met from the crane frame
through the front suspension to the SFO attachment point (See
“Truck Frame and Mounting Bolt Requirements for Front
Stabilizer” in this section).
RSOD
3 in (7,6 cm) MIN
204 in
(518 cm)
MIN
*8,100 lb
(3674 kg)
*9,250 lb
(4196 kg)
64 in
(163 cm)
MIN
180° FULL CAPACITY
WORK AREA
3 in (7,6 cm) MIN
*8,100 lb
(3674 kg)
*9,250 lb
(4196 kg)
204 in
(518 cm)
MIN
64 in
(163 cm)
MIN
RSOD
360° FULL CAPACITY
WORK AREA
113 in (287 cm)
MIN
SFO
Reference Only