Manitowoc National Crane NC1400H - Configuration 3 - 14100 H; Configuration 4 - 14100 H

National Crane Published 10-30-2014 Control # 040-09 7-5
1400H OPERATOR AND SERVICE MANUAL INSTALLATION
Configuration 3 - 14100H
This configuration allows full capacity in a 180° working
area over the rear of the truck.
Requires 20,000 lb (9072 kg) GAWRF, 40,000 lb (18 144
kg) GAWRR, 60,000 lb (27 215 kg) GVWR, RSOD rear
stabilizers and sub-base. Full capacity work area is rear 180°
of vehicle from outrigger to outrigger. Truck frame must have
or be capable of being reinforced to 30.0 in
3
S.M. (492 cm
3
)
and 3,300,000 lb-in (372 850 Nm) RBM under the crane,
spring hanger to spring hanger.
*Bare chassis weight.
Configuration 4 - 14100H
This mount requires front stabilizer for full capacity 360°
around the truck. Front stabilizer gives the machine a solid
base helping the operator control loads.
Requires 20,000 lb (9072 kg) GAWRF, 40,000 lb (18 144
kg) GAWRR, 60,000 lb (27 215 kg) GVWR, sub-base, SFO
and RSOD rear stabilizers. Truck must have 30.0 in
3
(492
cm
3
) section modulus and 3,300,000 lb-in (372 850 Nm) RBM
or be capable of being reinforced to this strength under the
crane frame through to the front suspension. Normally a
tapered frame cannot be reinforced to this requirement.
Additional truck frame requirements must be met from the
crane frame through the front suspension to the SFO
attachment point (See “Truck Frame and Mounting Bolt
Requirements for Front Stabilizer” in this section).
*Bare chassis weight.
RSOD
180° FULL CAPACITY
WORK AREA
3 in (7.6 cm) MIN
*8,100 lb
(3674 kg)
*9,250 lb
(4196 kg)
64 in
(163 cm)
MIN
192 in
(488 cm)
MIN
RSOD
360° FULL CAPACITY
WORK AREA
64 in
(163 cm)
MIN
192 in
(488 cm)
MIN
*9,250 lb
(4196 kg)
*8,100 lb
(3674 kg)
3 in (7,6 cm) MIN
113 in (287
cm)
MIN
SFO
Reference Only