OPERATING CONTROLS 1400H OPERATOR AND SERVICE MANUAL
2-10 Published 10-30-2014 Control # 040-09
Failure to reposition the anti-two-block switch
weight and properly connect the cord assemblies will
prevent the anti-two-block system from functioning
properly. No weight shall be on the main boom anti-two-
block switch when the boom extension is being used.
Installation of Anti-Two-Block Retainer in Locking
Position (see Fig. 1 and 2)
1. Pull the cable out of the switch and bend back parallel to
the boom and hold (1)
2. Slide the flag from left side with its slot over the cable
between the crimped stop and the switch (2). Push it
firmly straight onto the cable guide of the anti-two-block
switch (3).
3. Straighten the cable completely into the slot and release
the cable (4).
PUSH FLAG
ONTO SWITCH
PULL CABLE
SLIDE SLOT ON
FLAG OVER CABLE
STRAIGHTEN
CABLE INTO SLOT
& RELEASE
FIGURE 1
SETTING OF ANTI-TWO-BLOCK RETAINER
IN LOCKING POSITION
FIGURE 2
RETAINER IN LOCKING POSITION
TURN FLAG FOR
BEST OPERATOR
VISIBILITY
To Next Page
Loading...
