4-9
Section 4 Maintenance
Monthly Sanitizing Procedure
WARNING
Unplug unit before servicing or cleaning.
Electric Shock Hazard.
1.
Remove the front panel, paddle wheel, ice chute
and door assembly as shown on pages
4-1through 4-6.
2. Mix a solution of 3 ounces (100 ml) Manitowoc
cleaner per 1-gallon (4 liters) plain tap water.
3. Carefully clean all parts removed from inside
the bin with this cleaner. Clean the dispenser
bin, door assembly, and ice chute.
4. Rinse all cleaned parts with fresh, running tap
water.
5. Mix a solution of 1-ounce (30-ml) Manitowoc
sanitizer with 4 gallons (15 liters) plain tap
water.
6. Sanitize each part washed in the previous step
with this sanitizer solution. Sanitize and re-
assemble in this order:
Paddle wheel
Agitator
Paddle wheel pin
Ice chute assembly
Scrap ice tray
Front panel
7. Do not rinse dispenser parts after they are
sanitized. Allow parts to air dry.
8. After all dispenser parts are replaced, restore
power to the dispenser.
9. Turn the ice machine on.
10. Allow the ice machine to begin filling the
dispenser.
11. After three batches are in the dispenser, test the
dispenser operation.
To Next Page
Loading...
Need help?
General
