–53–
WATER INLET VALVE
Q0600C/Q0800C/Q1000C/QDUAL
The water inlet valve normally does not require
removal for cleaning. Follow the instructions below to
determine if removal is necessary.
1. Set the ICE/OFF/CLEAN switch to OFF. Locate the
water inlet (in the water area of the ice machine). It
directs water into the water trough.
2. When the ice machine is off, the water inlet valve
must completely stop water flow into the machine.
Watch for water flow. If water flows, remove,
disassemble and clean the valve.
3. When the ice machine is on, the water inlet valve
must allow the proper water flow through it. Set the
toggle switch to ON. Watch for water flow into the
ice machine. If the water flow is slow or only trickles
into the ice machine, remove, disassemble, and
clean the valve.
Continued on Next Page...
Disconnect the electric power to the ice machine at
the electric service switch box and turn off the water
supply before proceeding.
To Next Page
Loading...
Need help?
General