Maintenance Section 4
4-8
Part Number 000000966 03/09
PARTS REMOVAL FOR CLEANING/SANITIZING
Single Evaporator Ice Machines
A. Remove the water curtain
• Gently flex the curtain in the center and
remove it from the right side.
• Slide the left pin out.
B. Remove the ice thickness probe
• Compress the hinge pin on the top of the ice
thickness probe.
• Pivot the ice thickness probe to disengage
one pin then the other. The ice thickness
probe can be cleaned at this point without
complete removal. If complete removal is
desired, disconnect the ice thickness control
wiring from the control board.
C. Remove the water distribution tube
• Loosen the two outer screws (do not remove
screws completely they are retained to
prevent loss) and pull forward on the
distribution tube to release from slip joint.
• Disassemble distribution tube by loosening
the two (2) middle thumbscrews and dividing
the distribution tube into two pieces.
• Remove the water trough
• Depress tabs on right and left side of the water
trough.
• Allow front of water trough to drop as you pull
forward to disengage the rear pins.
NOTE: Distribution tube thumbscrews are retained to
prevent loss. Loosen thumbscrews but do not pull
thumbscrews out of distribution tube.
D. Remove the water level probe
• Pull the water level probe straight down to
disengage.
• Lower the water level probe until the wiring
connector is visible.
• Disconnect the wire lead from the water level
probe.
• Remove the water level probe from the ice
machine.
E. Remove the water pump.
• Grasp pump and pull straight down on pump
assembly until water pump disengages and
electrical connector is visible.
• Disconnect the electrical connector.
• Remove the water pump assembly from ice
machine.
• Do not soak the water pump motor in cleaner
or sanitizer solution.
F. Remove the evaporator tray from the bottom
of the evaporator. (when used)
• Loosen thumbscrew on left side of tray.
• Allow left side of tray to drop as you pull the
tray to the left side. Continue until the outlet
tube disengages from the right side.
• Proceed to page 4-12, Step 7.
To Next Page
Loading...
Need help?
General