To Next Page

To Previous Page

Section 4 Maintenance

Part Number 000000966 03/09 4-13

Step 16 The ice machine will stop after the sanitize

cycle (approximately *35 minutes). Place the toggle

switch in the OFF position and disconnect power to the

ice machine.

*S3300 Only - 80 minutes.

Step 17 Refer to step 6 and disassemble components.

After dissembling proceed to step 18.

Step 18 Mix a solution of sanitizer and warm water.

Step 19 Use 1/2 of the sanitizer/water solution to

sanitize all removed components. Use a cloth or sponge

to liberally apply the solution to all surfaces of the

removed parts or soak the removed parts in the

sanitizer/water solution. Do not rinse parts after

sanitizing.

Step 20 Use 1/2 of the sanitizer/water solution to

sanitize all foodzone surfaces of the ice machine and bin

(or dispenser). Use a cloth or sponge to liberally apply

the solution. When sanitizing, pay particular attention to

the following areas:

• Side walls

• Base (area above water trough)

• Evaporator plastic parts - including top, bottom and

sides

• Bin or dispenser

Do not rinse the sanitized areas.

Step 21 Install the removed parts, restore power and

place the toggle switch in the ICE position.

Warning

Disconnect the electric power to the ice machine at

the electric service switch box..

Solution Type Water Mixed With

Sanitizer 6 gal. (23 l) 4 oz (120 ml) sanitizer

Manitowoc S Installation, Use & Care Manual

Other manuals for Manitowoc S